Abstract:Impact is the most important factor affecting the reliability of Micro-Electro-Mechanical System (MEMS) gyroscopes, therefore corresponding reliability design is very essential. This paper proposes a shock-protected structure (SPS) capable of withstanding a full temperature range from ‚ąí40 ¬įC to 80 ¬įC to enhance the shock resistance of MEMS gyroscopes. Firstly, the shock transfer functions of the gyroscope and the SPS are derived using Single Degree-of-Freedom and Two Degree-of-Freedom models. The U-folded beam stiffness and maximum positive stress are deduced to evaluate the shock resistance of the silicon beam. Subsequently, the frequency responses of acceleration of the gyroscope and the SPS are simulated and analyzed in Matlab utilizing the theoretical models. Simulation results demonstrate that when the first-order natural frequency of the SPS is approximately one-fourth of the gyroscope's resonant frequency, the impact protection effect is best, and the SPS does not affect the original performance of the gyroscope. The acceleration peak of the MEMS gyroscope is reduced by approximately 23.5 dB when equipped with the SPS in comparison to its counterpart without the SPS. The anti-shock capability of the gyroscope with the SPS is enhanced by approximately 13 times over the full-temperature range. After the shock tests under the worst case, the gyroscope without the SPS experiences a beam fracture failure, while the performance of the gyroscope with the SPS remains normal, validating the effectiveness of the SPS in improving the shock reliability of MEMS gyroscopes.

Computer Simulation for Shock Resistance of Quartz Tuning Fork Gyroscope

Structure Design and Structural Parameter Optimization of Fully Symmetric Vibratory Gyroscope

Investigation Of Reliability Of Mems Gyroscopes Under Different Shock Conditions

Testing and mathematical approach on dynamics of a cymene-Si-oil shock absorber for structural integrity in vibration and impact protection

Design, Fabrication and Characterization of Disk Resonator Gyroscope with Vibration and Shock Resistance

Design of a Shock-Protected Structure for MEMS Gyroscopes over a Full Temperature Range

Analysis on Shock Resistance of Micromachined Angular Rate Sensor Based on Convection Heat Transfer

Shock resistance of MEMS capacitive accelerometers

3-D Dynamic Elastic–plastic FEA for Rotating Disk Indirect Bar–bar Tensile Impact Apparatus: Numerical Analysis for the Generation of Mechanically-Filtered Incident Stress Pulses

Dynamic Experimental Investigation On The Self-Vibration Characteristics Of Liquid Storage Tanks Under Seismic Excitations

Design and Simulation of Novel MEMS Resonant Gyroscope

A novel electrostatic-driven tuning fork micromachined gyroscope with a bar structure operating at atmospheric pressure

A novel multi-direction high shock reliability test on MEMS devices

Effect Of Transverse Force On The Performance Of Quartz Resonator Force Sensors

A Transfer Function Approach to Shock Duration Compensation for Laboratory Evaluation of Ultra-High-G Vacuum-Packaged MEMS Accelerometers

Design and Simulation of Micro-Platform for MEMS Devices Applied in Shock Environment.

Study on electrostatic self-excited driving for tuning fork micromachined gyroscope with large Q value

Design and implementation of a fully-decoupled tuning fork (FDTF) MEMS vibratory gyroscope for robustness improvement

2 MEMS ACCELEROMETERS AND SHOCK EXPERIMENTS 2 . 1 MEMS Accelerometers

Study on the Micro-vibration Suppression of a MnCu Spring Isolation Platform with Low Stiffness and High Damping

Experimental analysis of MEMS capacitive accelerometer's shock resistibility