Abstract:Surface acoustic wave gyroscopes (SAWGs), as a kind of all-solid-state micro-electro-mechanical system (MEMS) gyroscopes, can work normally under extremely high-impact environmental conditions. Among the current SAWGs, amplitude-modulated gyroscopes (AMGs) are all based on the same gyro effect, which was proved weak, and their sensitivity and intensity of the output are both lower than frequency-modulated gyroscopes (FMGs). However, because FMGs need to process a series of frequency signals, their signal processing and circuits are far less straightforward and simple than AMGs. In order to own both high-sensitivity and simple signal processing, a novel surface acoustic traveling wave gyroscope based on amplitude modulation is proposed, using one-dimensional phononic crystals (PCs) in this paper. In view of its specific structure, the proposed gyroscope consists of a surface acoustic wave oscillator and a surface acoustic wave delay line within a one-dimensional phononic crystal with a high-Q defect mode. In this paper, the working principle is analyzed theoretically through the partial wave method (PWM), and the gyroscopes with different numbers of PCs are also designed and studied by using the finite element method (FEM) and multiphysics simulation. The research results demonstrate that under a 1 V oscillator voltage output, the higher sensitivity of -23.1 mV·(rad/s)-1 in the linear range from -8 rad/s to 8 rad/s is reached when the gyro with three PC walls, and the wider linear range from -15 rad/s to 17.5 rad/s with the sensitivity of -6.7 mV·(rad/s)-1 with only one PC wall. Compared with the existing AMGs using metal dots to enhance the gyro effect, the sensitivity of the proposed gyro is increased by 15 to 112 times, and the linear range is increased by 4.6 to 186 times, even without the enhancement of the metal dots.

Structure Design and Structural Parameter Optimization of Fully Symmetric Vibratory Gyroscope

Effects of Structural Dimension Variation on the Vibration of MEMS Ring-Based Gyroscopes

A Bulk Micromachined Gyroscope With Improved Quality-Factors At Atmospheric Pressure

A Slot-Structure MEMS Gyroscope Working at Atmosphere With Tunable Electrostatic Spring Constant

A MICROMECHANICAL MODE-MATCHED GYROSCOPE USING STIFFNESS NONLINEARITY AND ELECTROSTATIC TUNING

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Design, Fabrication, and Characterization of a Multicurved Surface Fusion Metal Resonant Gyroscope

Design and optimization of a resonant output frequency gyroscope for robust sensitivity and bandwidth performance

Design of a Micro-Electro Mechanical System Quad Mass Gyroscope with Compliant Mechanical Amplification

Design and Optimization of a Novel SAW Gyroscope Structure Based on Amplitude Modulation with 1-D Phononic Crystals

Design and Fabrication of a Novel Wheel-Ring Triaxial Gyroscope

Design and implementation of a fully-decoupled tuning fork (FDTF) MEMS vibratory gyroscope for robustness improvement

Structural Optimization and Excitation Method of Metal-Shell Resonator Gyroscope Driven by Composite Electrodes

Research on the Configuration Optimization of All-Metal Micro Resonant Hemisphere

Design and Simulation of a Dual-Axis Sensing Decoupled Vibratory Wheel Gyroscope

Dynamical analysis of an improved MEMS ring gyroscope encircled by piezoelectric film

Optimization of Sensitivity for a Novelly-Designed MEMS Resonant Gyroscope

A Novel Microelectromechanical Resonant Gyroscope

Optimal Design Of A Center Support Quadruple Mass Gyroscope (Csqmg)

Design and Simulation of Novel MEMS Resonant Gyroscope

Design And Simulation Of A Completely Decoupled Micromechanical Gyroscope