Abstract:Impact is the most important factor affecting the reliability of Micro-Electro-Mechanical System (MEMS) gyroscopes, therefore corresponding reliability design is very essential. This paper proposes a shock-protected structure (SPS) capable of withstanding a full temperature range from ‚ąí40 ¬įC to 80 ¬įC to enhance the shock resistance of MEMS gyroscopes. Firstly, the shock transfer functions of the gyroscope and the SPS are derived using Single Degree-of-Freedom and Two Degree-of-Freedom models. The U-folded beam stiffness and maximum positive stress are deduced to evaluate the shock resistance of the silicon beam. Subsequently, the frequency responses of acceleration of the gyroscope and the SPS are simulated and analyzed in Matlab utilizing the theoretical models. Simulation results demonstrate that when the first-order natural frequency of the SPS is approximately one-fourth of the gyroscope's resonant frequency, the impact protection effect is best, and the SPS does not affect the original performance of the gyroscope. The acceleration peak of the MEMS gyroscope is reduced by approximately 23.5 dB when equipped with the SPS in comparison to its counterpart without the SPS. The anti-shock capability of the gyroscope with the SPS is enhanced by approximately 13 times over the full-temperature range. After the shock tests under the worst case, the gyroscope without the SPS experiences a beam fracture failure, while the performance of the gyroscope with the SPS remains normal, validating the effectiveness of the SPS in improving the shock reliability of MEMS gyroscopes.

Design and Simulation of Micro-Platform for MEMS Devices Applied in Shock Environment.

Micro-dielectric-droplet impingement cooling system based on MEMS

Micromachined Integrated Shock Protection Via A Self-Adaptive Nonlinear System

Investigation of a Complete Squeeze-Film Damping Model for MEMS Devices

Micromachined integrated self-adaptive nonlinear stops for mechanical shock protection of MEMS

A Novel Shock Protection Method Based On Mems Compliant Latching Stopper

Mechanical Latching Stops for Reliability Improvement of MEMS in Shock Environments

Shock resistance of MEMS capacitive accelerometers

A Novel Mems Shock Switch with Movable Contact Point to Prolong Contact Time

2 MEMS ACCELEROMETERS AND SHOCK EXPERIMENTS 2 . 1 MEMS Accelerometers

On Chip Electrostatic Discharge Protection for MEMS Gas Sensor System

A novel multi-direction high shock reliability test on MEMS devices

Shock-Resistibility of MEMS-Based Inertial Microswitch under Reverse Directional Ultra-High G Acceleration for IoT Applications

Design of a Shock-Protected Structure for MEMS Gyroscopes over a Full Temperature Range

Experimental analysis of MEMS capacitive accelerometer's shock resistibility

Flexible Stop and Double-Cascaded Stop to Improve Shock Reliability of Mems Accelerometer

Design and Contact Dynamics Simulation of an Inertia Micro-Switch Based on Non-Silicon Substrate

A Shock-Resistance Device Design with SMA Shells

A MEMS Inertial Switch Based on Nonsilicon Surface Micromachining Technology

Design and Simulation of MEMS Thermal and Vibration Isolator Based on PDMS Beam Arrays.

Research on Multiphysics-Driven MEMS Safety and Arming Devices