Abstract:Wide-viscosity-range impellers have extensive demands and applications in process industry. The gas–liquid dispersion and mass transfer characteristics of wide-viscosity-range impellers including Large-double-blade (LDB) impeller, Fullzone (FZ) impeller and Maxblend (MB) impeller in water solutions of xanthan gum were investigated experimentally and compared. The influences of gas flow rate, impeller speed and polymer concentration of liquid on the power consumption, overall gas holdup εg and mass transfer coefficient KLa were also analyzed. On this basis, the appropriate operating parameters and impeller type were determined. The results indicate that with rising flow rate, the higher εg and KLa can be achieved with a drop in power consumption, and a relatively high flow rate is recommended on the premise of guaranteeing the complete dispersal condition in aerated vessel. Higher impeller speed provides better gas–liquid dispersion and mass transfer performance, but results in more power consumption simultaneously. The appropriate impeller speed should be just enough to meet the requirements of εg and KLa. It also is found that the increasing concentration of water solution of xanthan gum adds to the complexity of gas dispersion and mass transfer in aerated vessel. Under the same specific power consumption PV, the εg and KLa are positive and negative correlation with the polymer concentration of liquid, respectively. Specially, when the concentration of water solution of xanthan gum is relatively low, the FZ impeller exhibits the best gas dispersion and mass transfer performance under the same specific power consumption. Nevertheless, the mass transfer performance of FZ impeller deteriorates significant when the concentration of water solution of xanthan gum increases to 1.00 wt%, and the MB impeller becomes the most appropriate impeller type in this condition.

Influence of Operating Conditions on Liquid-Solid Contact in the Feed Stock Zone of a Downer

A Quantitative Measurement System Focusing on Liquid-Solid Contact in the Feed Stock Zone of a Downer

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Dynamic and Steady-State Characterization of the Liquid Spray Zone in an Externally Heated Gas–Solid Fluidized Bed

Investigation of Gas–liquid Dispersion and Mass Transfer Performance of Wide-Viscosity-range Impellers in Water Solutions of Xanthan Gum

Effects of liquid action mechanisms on hydrodynamics in liquid-containing gas–solid fluidized bed reactor

Mass Transfer Characterization for Hydrocarbon Liquid–particle Collision Based on Sensitive Tracing of Fluorescent Probe

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

CFD-DEM Simulation of Flow and Mixing Behavior in Downers with Different Entrance Structures

Measuration of Gas-Liquid Interfacial Area in Rotating Drum Reactor by Chemical Method

Study on Hydrodynamics and Mass Transfer Characteristic of a New Gas-liquid Reactor

CFD simulation on shear-thinning gas-liquid dispersion in coaxial mixer

Bed-to-Wall Contact Dynamics in a Gas-Solid Fluidized Bed with Downward Solid Movement

Experimental Study on Gas–solid Flow and Heat Transfer Characteristics in Downer Moving Bed

Experiment on Screw Feeder at the Inlet of a Downer

Liquid-Solid Mass Transfer of Catalyst in a Reactive Distillation Column with Different Packing Method

Liquid droplet dispersion in a rotating packed bed: Experimental and numerical studies

RADIAL DISTRIBUTION CHARACTERISTICS OF LOCAL PARTICLE VELOCITY FOR BINARY PARTICLE MIXTURE IN DOWNERS

Cocurrent gas-solid downflow fluidized bed (downer) reactors: (III). Gas and solid mixing

Dispersion phenomena of liquid droplet impacting on the single fiber with different wettabilities

Solids Axial and Radial Mixing Behavior in Downer with Gas Jet in Reverse Direction