Abstract:Effect of varying surface structures of the inner rotating cylinder on characteristics of droplet formed in a liquid-liquid Taylor-Couette (TC) reactor is investigated. Two novel surface structures of inner cylinders, designed with axially corrugated surface (N40) and with typical three-dimensional roughness (NZ40), respectively, were adopted for the investigation. The high-speed camera visualization was used to measure the droplet size while CFD modelling was applied to predict the fluid dynamics of TC flows with such two inner cylinders and a smooth surface inner cylinder, thus revealing the effect of inner cylinder configuration on the droplet formation in the TC flows. The experimental results have clearly indicated that both the rotation speed and surface configuration variation of the inner cylinders affect the generated droplet size and distribution. As the rotation speed increases, the droplet size is obviously reduced for all types of inner cylinder configurations. Compared with the conventional smooth surface inner cylinder, the two new types of inner cylinders with special surface structures can produce much smaller droplets, especially for the case of N40 surface structure inner cylinder, with which the smallest droplet size was found at all the experimental conditions. CFD modelling results have demonstrated that the surface configurations of inner cylinder can significantly affect the turbulence generation, consequently altering the distributions of turbulent kinetic energy and local turbulence shear strain rate. As a result, the droplet size was found to be controlled by the change of the local turbulent dissipation rate that was strongly associated with the surface structures of inner cylinders. Empirical correlations that correlate the droplet size with the Weber number and Reynolds number were proposed based on the high-speed camera visualization data.(c) 2022 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY license (http:// creativecommons.org/licenses/by/4.0/).

Liquid droplet dispersion in a rotating packed bed: Experimental and numerical studies

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Dynamics of liquid dispersion in a rotating packed bed with single‐layer wire mesh

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Effect of Inner Cylinder Configuration on Liquid Droplet Dispersion and Size Distributions in a Taylor-Couette Reactor

Liquid dispersion behaviors in a rotating packed bed with different packing arrangements: A comparison study

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Dispersion characteristics of liquid jet impacting on the rotating single-layer wire mesh with different surface wettabilities

3D CFD simulation of the liquid flow in a rotating packed bed with structured wire mesh packing

Dispersion phenomena of liquid droplet impacting on the single fiber with different wettabilities

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

Effects of operating conditions on droplet deposition onto surface of atomization impinging spray

Dispersion behavior of liquid–liquid and gas–liquid two‐phase flow in micro‐packed beds

Simulation of Droplet-gas Flow in the Effervescent Atomization Spray with an Impinging Plate

Droplet impact on a concave wall in a rotating gas flow field

Modelling of 3D liquid dispersion in a rotating packed bed using an Eulerian porous medium approach

Novel Wire Mesh Packing with Controllable Cross-Sectional Area in a Rotating Packed Bed: Mass Transfer Studies

Numerical studies of dynamic behavior of liquid film on single-layer wire mesh with different wettabilities

Numerical studies of gas-solid flow behaviors and wall wear in a swirling fluidized bed

Liquid flow and breakage behaviors of two liquid jets impacting on the wire mesh with different impinging angles