Abstract:The granular motion of binary-size mixture in a three-dimensional rotating drum operating in the rolling regime is numerically tracked via the discrete element method (DEM), with a focus on the axial dispersion behavior of the different particle types in response to the inherent size-segregation. Accordingly, the evolution with time, the frequency distribution and the space-time profiles of the axial dispersion coefficients are evaluated. The results demonstrate that (i) the fast radial segregation gives rise to the sharp increase and decrease of the axial dispersion coefficients of respectively the large and small particles in both the active and passive regions; (ii) the axial dispersion coefficients in the active region is an order-of-magnitude higher than that in the passive region; (iii) after the radial segregation, the frequency distributions of the axial dispersion coefficients of the large particles, the small particles and all the particles are normal distributions; (iv) the greatest axial dispersion coefficients of both particle types are at the upper part of the active region near the bed surface; (v) increasing the rotating speed and particle diameter ratio clearly enhances the axial dispersion intenstity in the active and passive regions; and (vi) axial segregation results in the greatest axial dispersion near the end walls, while most of the rest of the drum exhibit equally low axial dispersion. The results obtained here contribute towards understanding the dynamical response of the axial dispersion of different particle types to the inevitable radial and axial segregation phenomena, and are expected to be valuable for improving operations and advancing theoretical models of such granular systems with constituents of different sizes.

Dynamics of liquid dispersion in a rotating packed bed with single‐layer wire mesh

Liquid droplet dispersion in a rotating packed bed: Experimental and numerical studies

Liquid dispersion behaviors in a rotating packed bed with different packing arrangements: A comparison study

Dispersion characteristics of liquid jet impacting on the rotating single-layer wire mesh with different surface wettabilities

3D CFD simulation of the liquid flow in a rotating packed bed with structured wire mesh packing

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

Study on the Numerical Model of Gas-Liquid Dispersion Driven by a Coaxial Mixer

Experimental Investigation on Solid Particle Distribution in Dense Solid–liquid Stirred Tank

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Formation of Liquid and Solid Bridges under the Interactions Between Droplet-Polyethylene Particle Pairs

Numerical Investigation of Liquid Dispersion by Hydrophobic/hydrophilic Mesh Packing Using Particle Method

Modelling of 3D liquid dispersion in a rotating packed bed using an Eulerian porous medium approach

Mass transfer modeling for viscous fluids in a disk-distributor rotating packed bed

Novel Wire Mesh Packing with Controllable Cross-Sectional Area in a Rotating Packed Bed: Mass Transfer Studies

Research on Particle Dispersion in a Plane Mixing Layer with Coherent Structures

Dispersion behavior of liquid–liquid and gas–liquid two‐phase flow in micro‐packed beds

CFD simulation on shear-thinning gas-liquid dispersion in coaxial mixer

Numerical Simulation of Interactions Between Rigid Rod-Like Polymers and Coherent Structures in a Mixing Layer

Research and development of advanced structured packing in a rotating packed bed

Three-dimensional axial dispersion dynamics of granular flow in the rolling-regime rotating drum

DEM investigation of the axial dispersion behavior of a binary mixture in the rotating drum