Abstract:Currently, with the increasing trend towards miniaturization and thinning of semiconductor devices, ensuring product reliability has become a crucial aspect in electronic packaging. This paper specifically focuses on MEMS temperature and humidity sensors and utilizes Moldex3D software for three-dimensional mold flow simulation analysis. The purpose of the analysis is to predict the distribution of potential air traps and identify the locations of weld lines. The influence of gate location and gate quantity on process defects and reliability issues is investigated using a single-factor method. The results clearly indicate that the design of the gate system has a significant impact on the reliability of sensor packaging. The simulation results for different gate locations demonstrate that placing the gate in the middle achieves a more balanced flow of epoxy resin. However, insufficient filling pressure in this configuration may result in an increase in the occurrence of air traps and weld lines. When multiple gates are used in the simulation, it is observed that the number of air traps does not decrease with an increase in the quantity of gates. Nonetheless, multiple gates promote a more balanced resin flow, although some convergence occurs, leading to the generation of numerous air traps at the convergence points. Additionally, excessive injection pressure can cause overflow and wire shifting at the window opening of the temperature and humidity sensor. In conclusion, the design of the gate system should carefully consider the structural characteristics of the product and the transfer molding process. It is evident that the gate system design plays a crucial role in the formation of air traps and weld lines. Therefore, a rational gate system design is vital to ensure both the yield and reliability of sensor products.

Reliability Optimization of a 3D Packaged Micro-machined Wind Sensor

Design and Optimization of Thermal-Mechanical Reliability of a TSV 3D Packaged Thermal Wind Sensor

Flip-Chip on Board Packaging of A Thermal Wind Sensor

Annular-Encapsulation Packaging To Realize High-Performance Mems Thermal Wind Sensor

Low-Drift MEMS Thermal Wind Sensor With Symmetric Packaging Using Plastic Injection Molding Process

Improvement of Thermo-Mechanical Reliability of Wafer-Level Chip Scale Packaging

Design and optimization of a TSV 3D packaged pressure sensor for high temperature and dynamic measurement

Wafer Level Packaging Based on AU-AU Bonding for a CMOS Compatible Thermal Wind Sensor

Investigation on the effect of the packaging-induced stress on the reliability of a MEMS sensor package

Effect of Packaging Asymmetry on the Performance of A 2d Mems Thermal Wind Sensor with Different Heating Geometries

Optimization of the thermal reliability of a four-tier die-stacked SiP structure using finite element analysis and the Taguchi method.

Low stress packaging of a micromachined accelerometer

Non-hermetic Opto-Electronic Packaging Based on Micro-Machined Silicon Bench Platform

Thermo-mechanical Reliability Analysis of 3D Stacked-Die Packaging with Through Silicon Via

Design, Test and Evaluation of a Novel Die-Attach Structure for Packaging Stress Suppression of MEMS Resonant Accelerometers

System-Level Optimization of MEMS Thermal Wind Sensor Based on the Co-Simulation of Macromodel and Board-Level Interface Circuits

Drie Trenches And Full-Bridges Design For Sensitivity Improvement Of Mems Silicon Thermal Wind Sensor

Stress Analysis and Structural Optimization of 3-D IC Package Based on the Taguchi Method

3D Integration and Thermal Analysis of MEMS Inertial Sensor with Air-Gapped Si-TSV

Ceramic Film Packaging for 2-D Thermal Wind Sensor Using LTCC Technology

Analysis and Compensation of Benchmark Drift of Micromachined Thermal Wind Sensor Caused by Packaging Asymmetry