Abstract:This article presents a novel fully differential four-path passive mixer first receiver architecture, offering a wide radio frequency (RF) bandwidth and improved out-of-band (OOB) rejection. The design utilizes a current reuse approach in the process voltage temperature (PVT) resistant complementary transimpedance amplifier (TIA) to achieve excellent noise performance while minimizing power consumption. Besides, the integration of a second-order Twin-T Elliptic Low-pass Notch filter (TTE-LPNF) followed by the TIA enhances the linearity performance of the receiver and helps achieve wideband response due to positive capacitive feedback and shunting notch. The active RC-based buffer circuit is designed to efficiently drive a 50 $\Omega$ load impedance while providing substantial bandwidth. Moreover, the paper proposed a novel clock generator architecture based on a passive polyphase filter (PPF) and digital combinational logic that has reduced the required input local oscillator (LO) frequency by half compared to the conventional architecture for the same LO output, therefore, reducing the clock power. As a proof of concept, the proposed receiver is fabricated in TSMC 180 nm CMOS technology, and measurement is performed in the lab at room temperature. The receiver demonstrates an impressive RF bandwidth of 200 MHz while operating smoothly within the frequency range of 0.5 -2.5 GHz. The proposed mixer first receiver has achieved a conversion gain of 29 dB, a noise figure (NF) of 5.8 dB at the LO frequency of 1 GHz, and an out-of-band third-order intercept point (OOB-IIP3) of $+$ 18.5 dBm with power dissipation of 27 mW in signal path and 34 mW in clock path while operating at 1.8 V.

A Novel Cascode Mixer for NB-IoT Transceiver System in 65nm CMOS

A Novel Power Mixer for NB-IoT Transmitter in 65-Nm CMOS

A Power Mixer Based Dual-Band Transmitter for NB-IoT Applications

A 0.1-1.9Ghz 65nm CMOS Variable-Gain Mixer-First Receiver with DSA and Noise-Shaping TIA.

A Highly-integrated Non-magnetic Passive Circulator Based on Rotary Traveling-wave Oscillator and Spatio-temporal Conductivity Modulation in 130 Nm CMOS

A Wideband 6-Bit Phase Shifter with Low RMS Error in 65nm CMOS Technology

A 5 GHz low power 0.18μm CMOS Gilbert cell mixer

A Low-Power NB-IoT Transceiver With Digital-Polar Transmitter in 180-nm CMOS.

A 0.7-2.5Ghz NB-loT/GNSS/BLE Hybrid PLL with PA Pulling Mitigation and Out-of-Band Phase Noise Reduction

A 0.5–2.5 GHz Mixer First Receiver With 200 MHz RF Bandwidth and $+$18.5 dBm OB-IIP3 in 180 nm CMOS for 5G NR Band

A 1.2V Low-Power Multi-Band Mixing Frequency Synthesizer for FDD System

A 62-90 GHz High Linearity and Low Noise CMOS Mixer Using Transformer-Coupling Cascode Topology

A Wideband and Low-Power Distributed Cascode Mixer Using Inductive Feedback

An All-Digital Quadrature RF Transmitter Front-End Using 3-bit ΣΔ Modulators in 65-nm CMOS

A Hybrid Coupler-First 5ghz Noise-Cancelling Dual-Mode Receiver with +10dbm In-Band IIP3 in Current-Mode and 1.7db NF in Voltage-Mode.

A 0.1 Similar To 4ghz Receiver And 0.1 Similar To 6ghz Transmitter With Reconfigurable 10 Similar To 100mhz Signal Bandwidth In 65nm Cmos

A Reconfigurable IF Receiver Supporting Intra-Band Non-Contiguous Carrier Aggregation in 65 Nm CMOS.

A 180nm CMOS wireless transceiver by utilizing guard band for narrowband IoT applications

An All-Digital Quadrature Rf Transmitter Front-End Using 3-Bit Sigma Delta Modulators In 65-Mm Cmos

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

A Blocker-Resilient Receiver with Second-Order Impedance Mapping for NB-IoT Applications