Abstract:This paper presents a low power Gaussian Frequency-Shift Keying (GFSK) transceiver (TRX) with high efficiency power management unit and integrated Single-Pole Double-Throw switch for Bluetooth low energy application. Receiver (RX) is implemented with the RF front-end with an inductor-less low-noise transconductance amplifier and 25% duty-cycle current-driven passive mixers, and low-IF baseband analog with a complex Band Pass Filter(BPF). A transmitter (TX) employs an analog phase-locked loop (PLL) with one-point GFSK modulation and class-D digital Power Amplifier (PA) to reduce current consumption. In the analog PLL, low power Voltage Controlled Oscillator (VCO) is designed and the automatic bandwidth calibration is proposed to optimize bandwidth, settling time, and phase noise by adjusting the charge pump current, VCO gain, and resistor and capacitor values of the loop filter. The Analog Digital Converter (ADC) adopts straightforward architecture to reduce current consumption. The DC-DC buck converter operates by automatically selecting an optimum mode among triple modes, Pulse Width Modulation (PWM), Pulse Frequency Modulation (PFM), and retention, depending on load current. The TRX is implemented using 1P6M 55-nm Complementary Metal-Oxide-Semiconductor (CMOS) technology and the die area is 1.79 mm2. TRX consumes 5 mW on RX and 6 mW on the TX when PA is 0-dBm. Measured sensitivity of RX is -95 dBm at 2.44 GHz. Efficiency of the DC-DC buck converter is over 89% when the load current is higher than 2.5 mA in the PWM mode. Quiescent current consumption is 400 nA from a supply voltage of 3 V in the retention mode.

A Low-Power NB-IoT Transceiver With Digital-Polar Transmitter in 180-nm CMOS.

A 180nm CMOS wireless transceiver by utilizing guard band for narrowband IoT applications

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

Two 180nm CMOS Wireless Transceivers for IoT Applications

A 54-67-ghz Low-Power Highly-Integrated Transceiver in 65-Nm CMOS for FMCW Radar Applications

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

Implementation of a New S-Band Micro-Transponder Based on Software Defined Radio

A CMOS Low Power K-band FMCW Radar Transceiver Front-End for AIOT Application

A Power Mixer Based Dual-Band Transmitter for NB-IoT Applications

A Low Power Reconfigurable Digital Polar Transmitter for IoT Applications

A DPLL-Centric Bluetooth Low-Energy Transceiver with a 2.3-Mw Interference-Tolerant Hybrid-Loop Receiver in 65-Nm CMOS

An ADPLL-centric Bluetooth Low-Energy Transceiver with 2.3mw Interference-Tolerant Hybrid-Loop Receiver and 2.9mw Single-Point Polar Transmitter in 65nm CMOS

A Sub-GHz Multimode Digital Polar Transmitter for 802.11ah and NB-IoT Applications

A Fully Integrated Bluetooth Low-Energy Transceiver with Integrated Single Pole Double Throw and Power Management Unit for IoT Sensors

A Novel Power Mixer for NB-IoT Transmitter in 65-Nm CMOS

A Single Chain 800m/1.8g/2.4ghz Multistandard Transceiver with Multibranch Transformer for Low-Cost IoT Applications.

A Fully-Integrated Reconfigurable Dual-Band Transceiver for Short Range Wireless Communications in 180 Nm CMOS.

A fully-integrated reconfigurable dual-band transceiver for short range wireless communication in 180nm CMOS

An All-Digital Quadrature RF Transmitter Front-End Using 3-bit ΣΔ Modulators in 65-nm CMOS

An All-Digital Quadrature Rf Transmitter Front-End Using 3-Bit Sigma Delta Modulators In 65-Mm Cmos

A Fully Integrated 60 Ghz 10 Gb/S Qpsk Transceiver With Digital Transmitter And T/R Switch In 65nm Cmos