Abstract:Cellular narrowband Internet-of-Things (NB-loT) is an important branch of low-power wide-area loT applications, which specifies multiple operation bands over 663 to 915MHz (LB) and 1710 to 2010MHz (MB), up to 23dBm output power for wide-range coverage, and low power consumption for longer battery life. Recently, Bluetooth Low Energy (BLE) at 2.4GHz band (HB) is integrated in NB-IoT modules to provide effective near-field maintenance for NB-IoT terminals, such as intelligent meters, smoke sensors etc. To simultaneously support multiple operation bands for user flexibility, separately optimized LB/MB NB-IoT power amplifiers (PAs) are implemented in [1], which increases design complexity and cost. With advantages of high efficiency, compact die area and direct interface to digital backend, scaling-friendly digital transmitters (DTXs) have become the research hotspot. The polar digital power amplifiers (DPAs) [2], [3] and DTXs [4] with high output power and high efficiency have been implemented to support NB-loT or BLE applications, but they require CORDIC, phase modulator, AM-PM synchronization and calibration circuits. The quadrature DTX has a simple and symmetrical architecture with good linearity, but it has lower output power and efficiency due to I/Q orthogonal combination. In addition, the up-sampling clock of digital baseband signal processing is usually integer-divided from the LO frequency to avoid fractional spurs. With the LO frequency varying over a wide frequency range, a complex fractional up-sampling module with variable ratios is required to match with input data-rate. In this work, a sliding digital-IF wideband quadrature DTX is proposed, which introduces a continuously sliding digital-IF digital upconverter (DUC) to replace the fractional up-sampling module, and realizes a compact wideband quadrature Doherty DPA with IQ-sharing technique to enhance output power and efficiency for multi-mode multi-band NB-loT/BLE applications.

An All-Digital Quadrature RF Transmitter Front-End Using 3-bit ΣΔ Modulators in 65-nm CMOS

An All-Digital Quadrature Rf Transmitter Front-End Using 3-Bit Sigma Delta Modulators In 65-Mm Cmos

An All-Digital Quadrature RF Transmitter with 8-Bit ΣΔ Modulation

The Design of All-Digital Polar Transmitter Based on ADPLL and Phase Synchronized ΔΣ Modulator

An All-Digital Reconfigurable RF Transmitter for Walkie-Talkie Applications Based on 1-Bit/3-bit Sigma-Delta Modulation

A 0.13µm CMOS 1.5-to-2.15ghz Low Power Transmitter Front-End for SDR Applications

A Digital ΣΔ Modulated Class-S Transmitter with Two-Step Up-conversion and Filter-less Front End

A 60 Ghz Low Power Direct-Conversion Quadrature-Phase Transmitter In 130 Nm Cmos With Low Profile Cavity Backed Antenna

A Wideband Sliding Digital-IF Quadrature Digital Transmitter for Multimode NB-IoT/BLE Applications

A Novel Low-Noise High-Linearity CMOS Transmitter for Mobile UHF RFID Reader

A 0.1&#x2013;5ghz SDR Transmitter with Dual-Mode Power Amplifier and Digital-Assisted I/Q Imbalance Calibration in 65nm CMOS

31.7 A 0.7-to-2.5ghz Sliding Digital-IF Quadrature Digital Transmitter Achieving >40% System Efficiency for Multi-Mode NB-IoT/BLE Applications

A RF Signal Generator for All-digital Transmitter

A 20dbm 2.4ghz Digital Outphasing Transmitter for WLAN Application in 32nm CMOS

A 1V 350μW 92dB SNDR 24 kHz ΔΣ modulator in 0.18μm CMOS

The Digital Front End with Dual-box Digital Pre-distortion in All-digital Quadrature Transmitter

A 3V 5.88mW 13b 400kHz Sigma-Delta Modulator with 84dB Dynamic Range

Band-pass Σ-Δ Modulator in RF Transceiver for Narrow-Band System

A Sub-GHz Multimode Digital Polar Transmitter for 802.11ah and NB-IoT Applications

The Implement Of Digital Front End In All-Digital Quadrature Rf Transmitter

A Low-Power NB-IoT Transceiver With Digital-Polar Transmitter in 180-nm CMOS.