Abstract:This article presents an ultralow-power (ULP) microelectromechanical system (MEMS)-based phase-tracking frequency shift keying (FSK) transceiver (TRX) with an embedded envelop detector-based on–off keying (OOK) wake-up receiver (WuRX). The system supports a shared antenna interface of FSK-matched filter for TRX and a matching network for the FSK receiver (RX) and OOK WuRX. To consume less power, the transmitter employs an adaptive fast switching (AFS) technique for FSK/OOK modulator and uses a high-Q MEMS resonator to get frequency stability. In addition, for better interference filtering, the MEMS-based modulator is shared to provide LO in FSK RX as it owns inherent sidelobe suppression. To support higher blocker/interference rejection with relatively low power, MEMS-based FSK-matched filter plus matching network with current-reuse LNA is co-designed to provide additional passive gain. Fabricated in 65-nm CMOS process, the transmitter (TX) generates FSK signals of −11.2 dBm output power at ISM-915 MHz and the data rate is up to 6 Mb/s. At 1 MHz offset, the measured phase noise (PN) is −140.2 and −139.3 dBc/Hz at 926.3 and 932.4 MHz, respectively. By sharing the modulator, the RX exhibits −36.2 dB in-band signal-to-interference ratio (SIR), −77.5 dBm sensitivity at bit error rate (BER) of working under 2 Mb/s data rate. The TX, FSK RX, and WuRX consume 642 @6 Mb/s, 520 @2 Mb/s, and 86 @200 kb/s, leading to the energy efficiency of 107, 260, and 430 pJ/b, respe- tively. The proposed TX achieves over better energy efficiency than state-of-the-art results and the FSK RX attains the best FoM with the sensitivity of −77.5 dBm, which are well suited for energy-efficient pico-IoT applications.

A Low Power Reconfigurable Digital Polar Transmitter for IoT Applications

The Design of All-Digital Polar Transmitter Based on ADPLL and Phase Synchronized ΔΣ Modulator

A Reconfigurable Digital Polar Transmitter with Open-Loop Phase Modulation for Sub-GHz Applications

A Sub-GHz Multimode Digital Polar Transmitter for 802.11ah and NB-IoT Applications

Multimode Baseband Signal Processing Module of a Digital Polar Transmitter for IoT Applications

A High-Efficiency Low-Voltage Class-E PA for IoT Applications in Sub-1 GHz Frequency Range

Two 180nm CMOS Wireless Transceivers for IoT Applications

A Low-Power NB-IoT Transceiver With Digital-Polar Transmitter in 180-nm CMOS.

A 180nm CMOS wireless transceiver by utilizing guard band for narrowband IoT applications

13.6 A 2.4GHz WLAN digital polar transmitter with synthesized digital-to-time converter in 14nm trigate/FinFET technology for IoT and wearable applications.

A DPLL-Centric Bluetooth Low-Energy Transceiver with a 2.3-Mw Interference-Tolerant Hybrid-Loop Receiver in 65-Nm CMOS

A Fully Integrated Reconfigurable Low-Power Sub-GHz Transceiver for 802.11ah in 65nm CMOS

A Fully-Integrated Wideband Digital Polar Transmitter with 11-Bit Digital-to-Phase Converter in 40nm CMOS.

An All-Digital Reconfigurable RF Transmitter for Walkie-Talkie Applications Based on 1-Bit/3-bit Sigma-Delta Modulation

A Low Power Impedance Transparent Receiver with Linearity Enhancement Technique for IoT Applications.

A Power Mixer Based Dual-Band Transmitter for NB-IoT Applications

An HDL-described Fully-synthesizable Sub-GHz IoT Transceiver with Ring Oscillator based Frequency Synthesizer and Digital Background EVM Calibration

A Reconfigurable Multi-Mode Multi-Band Transmitter with Integrated Frequency Synthesizer for Short-Range Wireless Communication

A Sub-GHz Low-Power Transceiver with PAPR-tolerant Power Amplifier for 802.11ah Applications

A 107 pJ/b TX 260 pJ/b RX Ultralow-Power MEMS-Based Transceiver With Wake-Up in ISM-Bands for IoT Applications