Abstract:Low-voltage clock generation and modulation are important to have dynamic voltage scaling for low-power SoC design or to enable the chip to be directly powered by energy harvesters for IoT applications. Even though the supply voltage of an integer-N PLL has reached 0.4V [1], designing a robust fractional-N PLL under 0.5V is still challenging as both a high-performance phase detector (PD) and an effective ΔΣ quantization noise (Q-noise) reduction method are required at low voltage. As shown at the top of Fig. 14.7.1, the time resolution of a DTC is severely degraded as supply voltage decreases, and the use of a circuit’s intrinsic time delay as reference base is not stable over PVT variations. Even though voltage-domain compensation methods [2, 3] achieve lower noise and better linearity, they must first convert the phase error from the time domain to the voltage domain, which causes nonlinearity issues and consumes significant voltage headroom for ultra-low-voltage (ULV) operations. To the best of authors’ knowledge, the lowest supply voltage for a published fractional-N PLL is 0.5V, but it uses an on-chip voltage booster to supply a higher internal voltage for the TDC [4] or must use large decoupling capacitors for the TDC in product-level designs. Given the fact that the use of a large decoupling capacitor with supply regulation is required in practice to achieve robust in-band noise performance, a time-interleaving flip-flop phase detector (TI-FFPD) has been proposed as an efficient PD structure, which achieves high linearity and low reference spur for a ring-VCO-based integer-N PLL [5]. By leveraging the advantage of the TI-FFPD, this paper presents a sub-0.5V bias-current-free fractional-N PLL with a calibration-free voltage-mode phase interpolator (VPI) for Q-noise cancellation, achieving sub-600fs rms jitter and <-57dBc worse-case fractional spur at 2.4GHz output.

A 0.7-2.5Ghz NB-loT/GNSS/BLE Hybrid PLL with PA Pulling Mitigation and Out-of-Band Phase Noise Reduction

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

A 0.8 V Low Power Low Phase-Noise Pll

A Low Phase Noise V-Band 40 Nm Cmos Phase Locked Loop For Wireless Communication

A 40 Ghz 65 Nm Cmos Phase-Locked Loop with Optimized Shunt-Peaked Buffer

A Low Phase Noise, Wideband and Compact CMOS PLL for Use in a Heterodyne 802.15.3c Transceiver

A Fractional-N PLL for Multiband (0.8–6 GHz) Communications Using Binary-Weighted D/A Differentiator and Offset-Frequency Δ-Σ Modulator

An Improved Low Phase Noise LC-VCO with Wide Frequency Tuning Range Used in CPPLL

A Compact 0.8–6ghz Fractional-N PLL with Binary-Weighted D/A Differentiator and Offset-Frequency Δ−Σ Modulator for Noise and Spurs Cancellation

A Low Power All-Digital PLL With −40dBc In-Band Fractional Spur Suppression for NB-IoT Applications

A Low Power All-Digital PLL with −40dbc In-Band Fractional Spur Suppression for NB-IoT Applications

A 4.7ghz Synchronized-Multi-Reference PLL with In-Band Phase Noise Lower Than Reference Phase $\text{noise +20}\Text{logn}_{\mathrm{d}\mathrm{i}\mathrm{v}}$

A 68.1-to-73.8ghz E-band Low Phase Noise QPLL with Amplifier Feedback QVCO in 65-Nm CMOS

A 56-To-66 Ghz Quadrature Phase-Locked Loop With A Wide Locking Range Divider Chain In 65nm Cmos

A low-noise, 0.05–17.8-GHz fractional-N phase-locked loop with two parallel synchronized dual-core voltage-controlled oscillators

A Low-Phase-Noise 8 GHz Linear-Band Sub-Millimeter-Wave Phase-Locked Loop in 22 nm FD-SOI CMOS

14.7 A 0.45V 0.72mw 2.4ghz Bias-Current-Free Fractional-N Hybrid PLL Using a Voltage-Mode Phase Interpolator in 28nm CMOS

A 6-12Ghz Wideband Programmable Phase-Locked Loop in 65 Nm CMOS

Low-noise Fractional-N PLL Design with Mixed-Mode Triple-Input LC VCO in 65nm CMOS

A 29.5 to 31.7 GHz PLL in 65 Nm CMOS Technology