Abstract:Wide frequency coverage phase locked loops (PLL) with fine frequency resolution and low phase noise are one of the most critical building blocks for the high speed communication systems. Voltage domain quantization scheme employing ADCs has been proposed in previous fractional-N PLLs as an alternative to DTC-based quantization cancellation. However, though the voltage-domain quantization is linear in modern processes, the potential nonlinearity in the time-to-voltage conversion preceding the ADC results in fractional spurs and noise folding, which will severely degrade the PLL output if not properly addressed. One approach applies linearity compensation that often requires sophisticated digital processing [1]–[2]. The other approach utilizes digital-to-time converters (DTC) or digital-to-analog converters (DAC) to generate a replica of the divider quantization noise and then cancels out this noise in the analog domain before it propagates into the loop [3]–[4], thus relaxing the requirement for linear phase detection range. Prior arts have achieved remarkable phase noise performances, at the cost of significantly higher design complexity. This work describes a wideband fractional-N PLL that uses an integrator-based time-to-voltage converter and a 10-bit SAR ADC for direct phase error digitization as shown in Fig. 1. Without linearity calibration or DTC/DAC-based quantization noise cancellation, the proposed PLL achieves low fractional spur and low jitter across a wide frequency range.

A Low Power All-Digital PLL with −40dbc In-Band Fractional Spur Suppression for NB-IoT Applications

A Low Power All-Digital PLL With −40dBc In-Band Fractional Spur Suppression for NB-IoT Applications

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

A Sub-mW Fractional-<inline-formula> &Lt;tex-Math Notation="latex">${n}$ &Lt;/tex-Math> &Lt;/inline-Formula> ADPLL with FOM of −246 Db for IoT Applications

A 0.8 V Low Power Low Phase-Noise Pll

A Fractional-N PLL for Multiband (0.8–6 GHz) Communications Using Binary-Weighted D/A Differentiator and Offset-Frequency Δ-Σ Modulator

A Compact 0.8–6ghz Fractional-N PLL with Binary-Weighted D/A Differentiator and Offset-Frequency Δ−Σ Modulator for Noise and Spurs Cancellation

A 0.98mw Fractional-N ADPLL Using 10b Isolated Constant-Slope DTC with FOM of −246db for IoT Applications in 65nm CMOS

A 2.1-GHz PLL with -80dBc/-74dBc reference spur based on aperture-phase detector and phase-to-analog converter

A 0.7-2.5Ghz NB-loT/GNSS/BLE Hybrid PLL with PA Pulling Mitigation and Out-of-Band Phase Noise Reduction

A Low-Power Digital Design of All Digital PLL for 2.4G Wireless Communication Applications.

An Ultra Low Power Integer-N PLL with a High-Gain Sampling Phase Detector for IOT Applications in 65 nm CMOS

A 0.001-Mm$$^{2}$$ 112.32-$$\Upmu $$W All-Digital PLL with Dual-Tuned DCO and Dual-Tuned Control Algorithm

A Low-Power and Small Chip-Area Fractional-N Digital PLL with Combination of DPI and TDC

A Fractional- N DTC-based ADPLL using path-select multi-delay line TDC and true fractional division technique

An 8-14Ghz 180Fs-Rms DTC-Less Fractional ADPLL with ADC-Based Direct Phase Digitization in 40nm CMOS

A 360μw Vernier Time-to-Digital Converter for ADPLL in IoT Applications

A 265-$\Mu$ W Fractional-${N}$ Digital PLL with Seamless Automatic Switching Sub-Sampling/Sampling Feedback Path and Duty-Cycled Frequency-Locked Loop in 65-Nm CMOS

A Calibration-Free 800 MHz Fractional-N Digital PLL With Embedded TDC

A 3.2-to-4.6 GHz Fast-Settling All-Digital PLL with Feed Forward Frequency Presetting.