Abstract:The field of local conductivity measurement has produced many kinds of scanning probes to measure the electricalcharacteristics at the nanoscale. However, due to the design limitations, no appropriate probe has been developed to measureand simultaneously image the electrical characteristics at 100 nm order. This research aims to fabricate a four-pOint AFMprobe in order to image electrical characteristics at 100 nm ord Four-point atomic force microscope probe for imaging the electrical characteristics of materials Lin ZHANG", Yang JU*2 and Atsushi HOSOI*2 *1Nagoya Univ. Dept. of Mechanical science and Engineering Furo-cho, Chikusa-ku, Nagoya 464-8603, Japan The field of local conductivity measurement has produced many kinds of scanning probes to measure the electrical characteristics at the nanoscale. However, due to the design limitations, no appropriate probe has been developed to measure and simultaneously image the electrical characteristics at 100 nm order. This research aims to fabricate a four-point AFM probe in order to image electrical characteristics at 100 nm order. Specifically, a certain tape of AFM probe for cell measurement e.g . Biolever, can be etched into four independent electrodes with an in-between space of 200 nm. The four electrodes are basically used to measure the electrical potential drop by allowing the electric current to pass through. The four-point probe is then integrated into a multimode AFM to realize the scanning and imaging simultaneously. The present experimental results show that the four-point probe fabricated can be used to image the surface topography of the Au nanowire, thereby permitting the simultaneous measurements of surface profiles and electrical characteristics of the samples at the next stage.

Nanoscale Mapping of the Surface Potential: Multifrequency Modulation Open-Loop Kelvin Probe Force Microscopy

Surface Potential Modeling and Reconstruction in Kelvin Probe Force Microscopy

Integrated Tapping Mode Kelvin Probe Force Microscopy with Photoinduced Force Microscopy for Correlative Chemical and Surface Potential Mapping

Excluding Contact Electrification in Surface Potential Measurement Using Scanning Kelvin Probe Microscopy.

Intermodulation electrostatic force microscopy for imaging surface photo-voltage

Single-Harmonic Response Open-Loop Kelvin-Probe Force Microscopy

Spatially Resolved High Voltage Kelvin Probe Force Microcopy: A Novel Avenue for Examining Electrical Phenomena at Nanoscale

Open Carbon Nanopipettes As Resistive-Pulse Sensors, Rectification Sensors, and Electrochemical Nanoprobes.

Novel Mlaps Using the Multilight and Digital Compensation Technique

The enzymatic transformation of water‐insoluble reactants in nonaqueous solvents. Conversion of cholesterol to cholest‐4‐ene‐3‐one by a Ncardia sp.

Nanoscale Imaging of Surface Topography and Reactivity with the Scanning Electrochemical Microscope

Integrated Tapping Mode Kelvin Probe Force Microscopy with Photoinduced Force Microscopy for Correlative Chemical and Surface Potential Mapping (Small 37/2021)

Kelvin Probe Force Microscopy and Its Application

Direct measurement of surface photovoltage by AC bias Kelvin probe force microscopy

Development of a New Microscopic Four-Point AFM Probe for the Measurement of Local Electrical Conductivity

Pulsed Force Kelvin Probe Force Microscopy-A New Type of Kelvin Probe Force Microscopy under Ambient Conditions

Electrokinetics In Micro-Channeled Cantilevers: Extending The Toolbox For Reversible Colloidal Probes And Afm-Based Nanofluidics

NOVEL AFM PROBE FOR LOCAL CONDUCTIVITY MEASUREMENT

Full data acquisition in Kelvin Probe Force Microscopy: Mapping dynamic electric phenomena in real space

Spatial mapping of photovoltage and light-induced displacement of on-chip coupled piezo/photodiodes by Kelvin probe force microscopy under modulated illumination

G030083 Four-point Atomic Force Microscope Probe for Imaging the Electrica1 Characteristics of Materials