Abstract:Scanning Kelvin Probe Microscopy (SKPM), a characterization method that could image surface potentials of materials at nanoscale, has extensive applications in characterizing the electric and electronic properties of metal, semiconductor and insulator materials. However, it requires deep understanding of the physics of the measuring process and being able to rule out factors that may cause artifacts to obtain accurate results.In the most commonly used dual-pass SKPM, the probe works in tapping mode to obtain surface topography information in first pass before lifting to a certain height to measure the surface potential. In this paper, we have demonstrated that the tapping-mode topography scan pass during the typical dual-pass SKPM measurement may trigger contact electrification between the probe and the sample, which leads to a charged sample surface and thus can introduce a significant error to the surface potential measurement.Contact electrification will happen when the probe enters into the repulsive force regime of tip-sample interaction and this can be detected by the phase shift of the probe vibration. In addition, the influences of scanning parameters, sample properties and probe's attributes have also been examined, in which lower free cantilever vibration amplitude, larger adhesion between the probe tip and the sample and lower cantilever spring constant of the probe are less likely to trigger contact electrification. Finally, we have put forward a guideline to rationally decouple contact electrification from surface potential measurement. They are decreasing the free amplitude, increasing the scanning amplitude, and using probes with lower spring constant.

Integrated Tapping Mode Kelvin Probe Force Microscopy with Photoinduced Force Microscopy for Correlative Chemical and Surface Potential Mapping (Small 37/2021)

Integrated Tapping Mode Kelvin Probe Force Microscopy with Photoinduced Force Microscopy for Correlative Chemical and Surface Potential Mapping

Kelvin Probe Force Microscopy and Its Application

Pulsed Force Kelvin Probe Force Microscopy-A New Type of Kelvin Probe Force Microscopy under Ambient Conditions

Intermodulation electrostatic force microscopy for imaging surface photo-voltage

Pulsed Force Kelvin Probe Force Microscopy through Integration of Lock-In Detection

Single-Harmonic Response Open-Loop Kelvin-Probe Force Microscopy

Surface Potential Modeling and Reconstruction in Kelvin Probe Force Microscopy

Electrokinetics In Micro-Channeled Cantilevers: Extending The Toolbox For Reversible Colloidal Probes And Afm-Based Nanofluidics

Full data acquisition in Kelvin Probe Force Microscopy: Mapping dynamic electric phenomena in real space

Spatially Resolved High Voltage Kelvin Probe Force Microcopy: A Novel Avenue for Examining Electrical Phenomena at Nanoscale

Electron Transfer/Ion Transfer Mode of Scanning Electrochemical Microscopy (secm): A New Tool for Imaging and Kinetic Studies

Spatial mapping of photovoltage and light-induced displacement of on-chip coupled piezo/photodiodes by Kelvin probe force microscopy under modulated illumination

Mapping fast evolution of transient surface photovoltage dynamics using G-Mode Kelvin probe force microscopy

Direct measurement of surface photovoltage by AC bias Kelvin probe force microscopy

3D Imaging and Quantitative Subsurface Dielectric Constant Measurement Using Peak Force Kelvin Probe Force Microscopy (Adv. Mater. Interfaces 2/2024)

Microwave Atomic Force Microscopy Imaging for Nanometer-Scale Electrical Property Characterization.

Probing the Nanonewton Mitotic Cell Deformation Force by Ion-Resonance-Enhanced Photonics Force Microscopy

Excluding Contact Electrification in Surface Potential Measurement Using Scanning Kelvin Probe Microscopy.

Simultaneous Nanomechanical and Electrochemical Mapping: Combining Peak Force Tapping Atomic Force Microscopy with Scanning Electrochemical Microscopy

Haptic Sensation-Based Scanning Probe Microscopy: Exploring Perceived Forces for Optimal Intuition-Driven Control