Abstract:The plastic deformation behavior of metal plates has been proved to be affected by loading paths. Plastic flow is a critical component in the mechanical description of plastic deformation, like yield and hardening. In this work, the anisotropic plastic flow of two metal plates (16MnCr5 and S420MC) under non-proportional loading conditions was investigated. Large specimens manufactured along different orientations were pre-tensioned up to various strain levels; subsequently, small uniaxial tensile specimens were cut from the pre-tensioned specimens along different orientations with the interval of 15°, and then loaded to rupture. Meanwhile, the r-value, a measure of anisotropic plastic flow, was recorded. Result shows that for the studied plates which had constant r-value in the monotonic uniaxial tensile tests, a downward evolution of the r-value against plastic strain was observed when the Schmitt angle of two stage loading directions was greater than 90°. As the plastic strain in the subsequent loading stage accumulated, the r-value dropped from a higher level to its original level within a strain range about 6.0%. Based on the transient r-value evolution, a HEXAH-based evolutionary plastic potential model was constructed within the framework of non-associated flow (non-AF) theory. In the model, a local ellipse-shape distortion of the plastic potential surface was defined during plastic deformation process and when the Schmitt angel exceeded 90°, such distortion caused a downward evolution of the r-value in the subsequent deformation. The calibration result indicates that the model could reproduce the transient r-value response relevant to loading path change. The proposed evolutionary plastic potential model can be applied together with different anisotropic hardening models in the non-AF theory to give a detailed description of the plastic deformation behavior and hopefully provide a solution for the accurate simulation of the complex sheet metal forming process.

Investigation on the Plastic Deformation During the Stamping of Ellipsoidal Heads for Pressure Vessels

Comparison of design methods for internally pressurized ellipsoidal head

A Method for Prediction of Forming Strain for Cold Stamping Formed Head Made of S30408 Austenitic Stainless Steel

Research on Prediction Method of Plastic Deformation for Cold Stamping Formed Standard Elliptical Head Made of Austenitic Stainless Steel

Research on aluminum alloy sheet thermoplastic deformation behavior based upon warm bulging test

A New Method for Preventing Plastic Collapse of Ellipsoidal Head under Internal Pressure

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

A Simple Formula for Prediction of Plastic Collapse Pressure of Steel Ellipsoidal Heads under Internal Pressure

COMPARISON OF ELLIPSOIDAL AND EQUIVALENT TORISPHERICAL HEADS UNDER INTERNAL PRESSURE: BUCKLING, PLASTIC COLLAPSE AND DESIGN RULES

Strength investigation on high pressure vessel with hemispherical head thinner than that of cylinder

Study on the Effects of Forming Parameters on the Plastic Flow of Axisymmetrical Curved Parts in Stamping Process

Autofrettage and Shakedown Analyses of an Internally Pressurized Thick-Walled Spherical Shell Based on Two Strain Gradient Plasticity Solutions

Numerical investigation of controllable non-uniform deformation of tailor-welded blanks using heterogeneous pressure-carrying medium

Method for Shape Imperfection Control in Buckling of Ellipsoidal Heads Using a 3D Laser Scanner

Experimental and Modeling Investigation on Anisotropic Plastic Flow of Metal Plates under Nonproportional Loading Conditions

Study on the spinning process of thin-walled aluminum alloy vessel head

Structure Design on Thermoplastic Composites Considering Forming Effects

Effect of Shape Imperfection on the Buckling of Large-Scale Thin-Walled Ellipsoidal Head in Steel Nuclear Containment

Investigation of forming defects in 5A06 aluminum alloy cold stamping of thin-walled shell with corner

Experimental Research on Deformation and Dimensional Accuracy of Rectangular-Section Tubular Part During Open Die Hydro-Pressing Process

Die Structure Analysis Of Stress Distribution During High-Strength Steel Stamping Process And Experimental Validation