Abstract:High boiling point heavy tar compounds such as pyrene and naphthalene are key factors causing corrosion and blockage in the pipelines of biomass thermal utilization equipment, and catalytic reforming represents an effective means to address heavy tar issues. Biomass carbon, characterized by its cost-effectiveness, high efficiency, and environmental friendliness, is envisioned as a catalyst carrier with extensive application prospects. In this study, the tar produced by a biomass fixed-bed gasifier was investigated, with an initial analysis of the pyrolysis process and definition of its different stages conducted. It was discovered that the condensation and secondary cracking stages are the predominant phases for the formation of heavy tars, including polycyclic aromatic hydrocarbons (PAHs). Carbon-based carriers were prepared using apricot shell as the raw material, and biomass carbon-based catalysts were synthesized via impregnation methods. The heavy tar extracted from the original tar through distillation was utilized in the hydrogen production tests of steam catalytic reforming with biomass carbon-based catalysts. The investigation into the impact of temperature, steam-to-tar mass ratio (S/T), and tar-to-catalyst mass ratio (T/C) on the catalytic reforming of tar has been conducted. In considering a variety of parameters, including hydrogen production rate, tar conversion rate, and the volume of hydrogen generated, it was found that under the conditions of 800 °C, S/T = 3, and T/C = 2, the Ni/C catalyst yielded the highest amount of hydrogen (91.52 g H2/kg tar) with a tar conversion rate of 93.30 %. The Ni-Co/C composite catalyst exhibited stronger catalytic activity and superior deactivation resistance compared to the monometallic catalysts. For the latter, steam regeneration methods effectively restored the catalytic activity of the carbon-based catalysts, enhancing the hydrogen yield rates of Ni/C and Co/C catalysts by 2.74 and 1.55 times respectively.

Low-Temperature Catalytic Cracking of Biomass Gasification Tar over Ni/HZSM-5

Heterogeneous Cracking Reaction of Tar over Biomass Char, Using Naphthalene As Model Biomass Tar

Performance of catalytic cracking of biomass tar and catalyst preparation

Catalytic cracking of tar component from high-temperature fuel gas

Low-Temperature Steam Reforming of Toluene and Biomass Tar over Biochar-Supported Ni Nanoparticles

Experimental Study on Catalytic and Thermal Cracking of Tar from Biomass Pyrolysis

Nickel catalyst in coupled plasma-catalytic system for tar removal

PERFORMANCE OF CATALYTIC CRACKING OF BIOMASS TAR

Enhanced H 2 -Rich Gas Production via Steam Reforming of Toluene over Ni-Based Hydrotalcite-Derived Catalysts at Low Temperature

Experimental study on hydrogen production from heavy tar in biomass gasification furnace catalyzed by carbon-based catalysts

Comparative evaluation of tar steam reforming over graphitic carbon supported Ni and Co catalysts at low temperature

Catalytic Conversion of Tar from Hot Coke Oven Gas Using 1-Methylnaphthalene As a Tar Model Compound

Catalytic Tar Conversion in Two Different Hot Syngas Cleaning Systems

Catalytic performance of activated lignite chars on biomass tar cracking

Influence of Catalytic Cracking of Tar on Gas Component

Development of nano-niO/Al2O3 catalyst to be used for tar removal in biomass gasification

Conversion of Biomass-Derived Tars in a Fluidized Catalytic Post-Gasification Process

Enhanced degradation of VOCs from biomass gasification catalyzed by Ni/HZSM-5 series catalyst

Preparation of highly dispersed lignite-char-supported cobalt catalyst for stably steam reforming of biomass tar at low temperature

Catalytic Behaviors of Porous Ni/dolomite Pellets for Decomposition of Tar from Biomass Gasification

Steam Reforming of Biomass Tar Model Compounds over Monolithic Catalysts