Abstract:High boiling point heavy tar compounds such as pyrene and naphthalene are key factors causing corrosion and blockage in the pipelines of biomass thermal utilization equipment, and catalytic reforming represents an effective means to address heavy tar issues. Biomass carbon, characterized by its cost-effectiveness, high efficiency, and environmental friendliness, is envisioned as a catalyst carrier with extensive application prospects. In this study, the tar produced by a biomass fixed-bed gasifier was investigated, with an initial analysis of the pyrolysis process and definition of its different stages conducted. It was discovered that the condensation and secondary cracking stages are the predominant phases for the formation of heavy tars, including polycyclic aromatic hydrocarbons (PAHs). Carbon-based carriers were prepared using apricot shell as the raw material, and biomass carbon-based catalysts were synthesized via impregnation methods. The heavy tar extracted from the original tar through distillation was utilized in the hydrogen production tests of steam catalytic reforming with biomass carbon-based catalysts. The investigation into the impact of temperature, steam-to-tar mass ratio (S/T), and tar-to-catalyst mass ratio (T/C) on the catalytic reforming of tar has been conducted. In considering a variety of parameters, including hydrogen production rate, tar conversion rate, and the volume of hydrogen generated, it was found that under the conditions of 800 °C, S/T = 3, and T/C = 2, the Ni/C catalyst yielded the highest amount of hydrogen (91.52 g H2/kg tar) with a tar conversion rate of 93.30 %. The Ni-Co/C composite catalyst exhibited stronger catalytic activity and superior deactivation resistance compared to the monometallic catalysts. For the latter, steam regeneration methods effectively restored the catalytic activity of the carbon-based catalysts, enhancing the hydrogen yield rates of Ni/C and Co/C catalysts by 2.74 and 1.55 times respectively.

Experimental Study on the Cracking of Tar Derived from Municipal Solid Waste Gasification to Produce Syngas

Experimental Study on Catalytic and Thermal Cracking of Tar from Biomass Pyrolysis

Cracking of Model Tar Species from the Gasification of Municipal Solid Waste Using Commercial and Waste-Derived Catalysts

Pulsed Corona Tar Cracker

Effect of Cellulose and Polyvinyl Chloride Interactions on the Catalytic Cracking of Tar Contained in Syngas

Catalytic cracking of tar derived from the pyrolysis of municipal solid waste fractions over biochar

Potential of tire pyrolysis char as tar-cracking catalyst in solid waste and biomass gasification

Influence of Catalytic Cracking of Tar on Gas Component

CATALYTIC CRACKING OF TAR DERIVED FROM BIOMASS PYROLYSIS

Investigation on Model Compound of Biomass Gasification Tar Cracking in Microwave Furnace: Comparative Research

Low-Temperature Catalytic Cracking of Biomass Gasification Tar over Ni/HZSM-5

Experimental Study on Tar Cracking in Coal Pyrolysis and Gasification Process

Hydrogen-rich Syngas Production by Catalytic Cracking of Tar in Wastewater under Supercritical Condition

Experimental study on hydrogen production from heavy tar in biomass gasification furnace catalyzed by carbon-based catalysts

Mechanism of In-Situ Catalytic Cracking of Biomass Tar over Biochar with Multiple Active Sites

Preparation and characterization of furfural residue derived char-based catalysts for biomass tar cracking

Generation features and kinetics of gas products in bio-tar catalytic cracking by char for biomass gasification

Catalytic Cracking of Toluene As A Tar Model Compound Using Sewage-Sludge-Derived Char

Catalytic performance of activated lignite chars on biomass tar cracking

Catalytic Materials Based on the Catalytic Cracking of Biomass Tar

Effects of Catalyst Particle Size and Mass on Catalytic Cracking of Biomass Pyrolysis Tar