Abstract:The use of Ni-based catalysts is a common method for eliminating tar through catalytic cracking. Carbon deposition is the main cause of deactivation in Ni/ZSM-5 catalysts, with filamentous MWCNTs being the primary form of carbon deposits. This study investigates the formation and evolution of CNTs during the catalytic process of biomass tar to explore the mechanism behind carbon deposition. The effect of the 9Ni/10MWCNTs/81ZSM-5 on toluene reforming was investigated through a vertical furnace. Gases produced by tar catalysis were evaluated through GC analysis. The physicochemical structure, properties and catalytic performance of the catalyst were also tested. TG analysis was used to assess the accumulation and oxidation reactivity of carbon on the catalyst surface. An analysis was conducted on the mechanism of carbon deposition during catalyst deactivation in tar catalysis. The results showed that the 9Ni/91ZSM-5 had a superior toluene conversion of 60.49%, but also experienced rapid and substantial carbon deposition up to 52.69%. Carbon is mainly deposited as curved filaments on both the surface and pore channels of the catalyst. In some cases, tip growth occurs where both carbon deposition and Ni coexist. Furthermore, specific surface area and micropore volume are reduced to varying degrees due to carbon deposition. With the time increased, the amount of carbon deposited on the catalyst surface increased to 62.81%, which gradually approached saturation, and the overall performance of the catalyst was stabilized. This situation causes toluene molecules to detach from the active sites within the catalyst, hindering gas release, which leads to reduced catalytic activity and further carbon deposition. It provides both a basis for the development of new catalysts and an economically feasible solution for practical tar reduction and removal.

Nickel catalyst in coupled plasma-catalytic system for tar removal

Plasma-Catalytical Removal of Tars from Fuel Gas Obtained by Biomass Gasification

Tar Removal from Biomass-Derived Fuel Gas by Pulsed Corona Discharges

Decomposition of Tars on a Nickel Honeycomb Catalyst

Catalytic Tar Conversion in Two Different Hot Syngas Cleaning Systems

Nickel-based catalysts for tar reduction in biomass gasification

Development of nano-niO/Al2O3 catalyst to be used for tar removal in biomass gasification

Chemical Processes in Tar Removal from Biomass Derived Fuel Gas by Pulsed Corona Discharges

Enhanced Reforming of Mixed Biomass Tar Model Compounds Using a Hybrid Gliding Arc Plasma Catalytic Process

Low-Temperature Catalytic Cracking of Biomass Gasification Tar over Ni/HZSM-5

Conversion of Biomass-Derived Tars in a Fluidized Catalytic Post-Gasification Process

Study on the mechanism of carbon nanotube-like carbon deposition in tar catalytic reforming over Ni-based catalysts

Enhanced H 2 -Rich Gas Production via Steam Reforming of Toluene over Ni-Based Hydrotalcite-Derived Catalysts at Low Temperature

Destruction of biomass tar model compound in a rotating gliding arc plasma catalytic system: Contribution of typical transition metals in Ni-based bimetallic catalyst

In-situ removal of toluene as a biomass tar model compound using NiFe2O4 for application in chemical looping gasification oxygen carrier

Catalytic Pyrolysis of Tar Model Compound with Various Bio-Char Catalysts to Recycle Char from Biomass Pyrolysis

Tar Removal in Pine Pyrolysis Catalyzed by Bio-Char Supported Nickel Catalyst

Microwave reforming with char-supported Nickel-Cerium catalysts: A potential approach for thorough conversion of biomass tar model compound

Coupled Plasma-Catalytic System with Rang 19pr Catalyst for Conversion of Tar

Synthesis of biomimetic monolithic biochar-based catalysts for catalytic decomposition of biomass pyrolysis tar

Seeded-growth Preparation of High-Performance Ni/MgAl2O4 Catalysts for Tar Steam Reforming