Abstract:This brief describes the design and characteristics of a wideband low-noise transconductance amplifier (LNTA) based on cascode inverter cells for use in surface acoustic wave (SAW) filter-less receivers (RXs). Compared to conventional low-noise amplifiers (LNAs), LNTAs offer superior linearity as they process signals in the current mode. A novel derivative superposition (DS) method is introduced to enhance the third-order input intercept point (IIP3), and the noise canceling (NC) technique is employed to overcome the inherent trade-off between noise figure (NF) and wideband input impedance matching. The circuit design process is accelerated using Bayesian optimization. Furthermore, the NF and IIP3 of the LNTA can be tuned by adjusting the input bias voltage. The chip is fabricated using 40-nm low-power (LP) CMOS technology. Experimental results demonstrate that the S11 is lower than -10 dB in the frequency range of 0.1-1.95 GHz, with a maximum transconductance gain of 126 mS and a minimum NF of 1.5 dB. The average IIP3 and output 1 dB compression point (OP1dB) over the frequency band is 4 dBm and 1.6 dBm, respectively. The blocker NF is 4.25 dB under a -15 dBm blocker and the blocker P1dB is -19.9 dBm. The power dissipation is 22 mW at a 1.25 V supply. Notably, the chip occupies only 0.0032 mm without on-chip inductors and capacitors.

A Common Source Lnta Of High Linearity Robust To Temperature And Process

New Linearization Implementations Improving IIP3 of Wideband LNTA by More Than 14Db

A Highly Linear 2.4GHz Low Noise Amplifier

Robustness Enhancement Technique and Fine-Tuning Technique of IIP3 for Wideband LNTA

A Highly Linear Wideband CMOS LNTA Employing Noise/Distortion Cancellation and Gain Compensation.

High-Linearity Direct Conversion Receiver with the Transconductance Equalization Technique and DCOC Method

A 0.9V 0.1-4Ghz LNTA in 28-Nm CMOS Achieving +11.3dbm IIP3 with Self-loaded Linearization Technique.

Design of Differential Variable-Gain Transimpedance Amplifier in 0.18 Μm SiGe BiCMOS

A 4 Dbm Ip1db 20.8 Dbm Iip3 Wideband Complementary Sf Feedback Lnta With Derivative Superposition Method

A Wideband BiCMOS Thermal Noise Canceling Low Noise Amplifier with Temperature Compensation

A New Cmos Current Reference with High Order Temperature Compensation

Highly linear OTA with 3rd-order nonlinearity superposition techniques for Gm-C low-pass filter with 34dBm IIP3

6.8 Mw 15 Dbm IIP3 CMOS Common‐gate LNA Employing Post‐linearisation Technique

A 0.06 Mm2 6 Dbm IB1db Wideband CMOS Class-Ab LNTA for SAW-less Applications

A Highly Linear Low Noise Amplifier With Wide Range Derivative Superposition Method

Analysis and Design of a 0.6- to 10.5-GHz LNTA for Wideband Receivers

A Compact 0.1-1.95 GHz, 1.5 Db NF LNTA Based on Cascode Inverters

New Implementation of High Linear LNA Using Derivative Superposition Method

A Novel Curvature-Compensated High Accuracy CMOS Bandgap Reference

A complementary ternary inverter based on the line tunneling field effect transistors

A 44gbit/s Wide-Dynamic Range and High-Linearity Transimpedance Amplifier in 130nm BiCMOS Technology