Abstract:This brief describes the design and characteristics of a wideband low-noise transconductance amplifier (LNTA) based on cascode inverter cells for use in surface acoustic wave (SAW) filter-less receivers (RXs). Compared to conventional low-noise amplifiers (LNAs), LNTAs offer superior linearity as they process signals in the current mode. A novel derivative superposition (DS) method is introduced to enhance the third-order input intercept point (IIP3), and the noise canceling (NC) technique is employed to overcome the inherent trade-off between noise figure (NF) and wideband input impedance matching. The circuit design process is accelerated using Bayesian optimization. Furthermore, the NF and IIP3 of the LNTA can be tuned by adjusting the input bias voltage. The chip is fabricated using 40-nm low-power (LP) CMOS technology. Experimental results demonstrate that the S11 is lower than -10 dB in the frequency range of 0.1-1.95 GHz, with a maximum transconductance gain of 126 mS and a minimum NF of 1.5 dB. The average IIP3 and output 1 dB compression point (OP1dB) over the frequency band is 4 dBm and 1.6 dBm, respectively. The blocker NF is 4.25 dB under a -15 dBm blocker and the blocker P1dB is -19.9 dBm. The power dissipation is 22 mW at a 1.25 V supply. Notably, the chip occupies only 0.0032 mm without on-chip inductors and capacitors.

A 0.9V 0.1-4Ghz LNTA in 28-Nm CMOS Achieving +11.3dbm IIP3 with Self-loaded Linearization Technique.

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A Highly Linear 2.4GHz Low Noise Amplifier

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

New Linearization Implementations Improving IIP3 of Wideband LNTA by More Than 14Db

A Highly Linear Wideband CMOS LNTA Employing Noise/Distortion Cancellation and Gain Compensation.

A 0.06 Mm2 6 Dbm IB1db Wideband CMOS Class-Ab LNTA for SAW-less Applications

Analysis and Design of a 0.6- to 10.5-GHz LNTA for Wideband Receivers

6.8 Mw 15 Dbm IIP3 CMOS Common‐gate LNA Employing Post‐linearisation Technique

A 4 Dbm Ip1db 20.8 Dbm Iip3 Wideband Complementary Sf Feedback Lnta With Derivative Superposition Method

A 2.8–10-GHz CMOS Current Reuse Cascaded Linearity Improving Ultra-Wideband Low-Noise Amplifier

A 0.18 Mu M Cmos Ultra-Wideband Low-Noise Amplifier With High Iip3

A 22-32.7 GHz Linearized LNA in 65-nm CMOS Using Multigate Transistor Technique

A 1.0–5.0ghz Tunable LNA with Automatic Frequency Calibration in 65 Nm CMOS

A Compact 0.1-1.95 GHz, 1.5 Db NF LNTA Based on Cascode Inverters

A 0.1–3.5-Ghz Inductorless Noise-Canceling CMOS LNA with IIP3 Optimization Technique

A fully integrated 0.18-/spl mu/m CMOS low noise amplifier for 2.4-GHz applications

A 0.03-3Ghz Inductorless Wideband Low Noise Amplifier in 65nm CMOS

A dual band CMOS two-stage variable gain low noise amplifier