Abstract:This brief describes the design and characteristics of a wideband low-noise transconductance amplifier (LNTA) based on cascode inverter cells for use in surface acoustic wave (SAW) filter-less receivers (RXs). Compared to conventional low-noise amplifiers (LNAs), LNTAs offer superior linearity as they process signals in the current mode. A novel derivative superposition (DS) method is introduced to enhance the third-order input intercept point (IIP3), and the noise canceling (NC) technique is employed to overcome the inherent trade-off between noise figure (NF) and wideband input impedance matching. The circuit design process is accelerated using Bayesian optimization. Furthermore, the NF and IIP3 of the LNTA can be tuned by adjusting the input bias voltage. The chip is fabricated using 40-nm low-power (LP) CMOS technology. Experimental results demonstrate that the S11 is lower than -10 dB in the frequency range of 0.1-1.95 GHz, with a maximum transconductance gain of 126 mS and a minimum NF of 1.5 dB. The average IIP3 and output 1 dB compression point (OP1dB) over the frequency band is 4 dBm and 1.6 dBm, respectively. The blocker NF is 4.25 dB under a -15 dBm blocker and the blocker P1dB is -19.9 dBm. The power dissipation is 22 mW at a 1.25 V supply. Notably, the chip occupies only 0.0032 mm without on-chip inductors and capacitors.

Analysis and Design of a 0.6- to 10.5-GHz LNTA for Wideband Receivers

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

Analysis and Design of Wideband Low Noise Amplifier with Digital Control

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A Gm-boosted and current peaking wideband merged LNA and mixer

A 6.5-12 GHz Balanced Variable Gain Low-Noise Amplifier with Frequency-Selective Non-Foster Gain Equalization Technique

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

A Compact 0.1-1.95 GHz, 1.5 Db NF LNTA Based on Cascode Inverters

A 0.06 Mm2 6 Dbm IB1db Wideband CMOS Class-Ab LNTA for SAW-less Applications

A 0.9V 0.1-4Ghz LNTA in 28-Nm CMOS Achieving +11.3dbm IIP3 with Self-loaded Linearization Technique.

0.6–3-Ghz Wideband Receiver RF Front-End with a Feedforward Noise and Distortion Cancellation Resistive-Feedback LNA

A 8.1 Mw 0.1∼2 GHz Inductorless CMOS LNTA for Software-Defined Radio Applications.

A Highly Linear Wideband CMOS LNTA Employing Noise/Distortion Cancellation and Gain Compensation.

Analysis and Design of a 2-40.5 GHz Low Noise Amplifier With Multiple Bandwidth Expansion Techniques

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

Analysis and Design of a 0.9 V 1 GHz-BW 14.6 Dbm-Oip3 Broadband Receiver with Current-Mode Analog Baseband in 12 Nm FinFET CMOS

A 4 Dbm Ip1db 20.8 Dbm Iip3 Wideband Complementary Sf Feedback Lnta With Derivative Superposition Method