Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

A 4 Dbm Ip1db 20.8 Dbm Iip3 Wideband Complementary Sf Feedback Lnta With Derivative Superposition Method

A 0.06 Mm2 6 Dbm IB1db Wideband CMOS Class-Ab LNTA for SAW-less Applications

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A Highly Linear 2.4GHz Low Noise Amplifier

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A Wideband BiCMOS Thermal Noise Canceling Low Noise Amplifier with Temperature Compensation

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A Highly Linear Wideband CMOS LNTA Employing Noise/Distortion Cancellation and Gain Compensation.

A 0.9V 0.1-4Ghz LNTA in 28-Nm CMOS Achieving +11.3dbm IIP3 with Self-loaded Linearization Technique.

A Compact 0.1-1.95 GHz, 1.5 Db NF LNTA Based on Cascode Inverters

A Highly Linear Low Noise Amplifier With Wide Range Derivative Superposition Method

New Linearization Implementations Improving IIP3 of Wideband LNTA by More Than 14Db

Analysis and Design of a 0.6- to 10.5-GHz LNTA for Wideband Receivers

A+21.2 Dbm Out-Of-Band Iip3 0.2-3ghz Rf Front-End Using Impedance Translation Technique

6.8 Mw 15 Dbm IIP3 CMOS Common‐gate LNA Employing Post‐linearisation Technique

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

A 0.18 Mu M Cmos Ultra-Wideband Low-Noise Amplifier With High Iip3

A 2.8–10-GHz CMOS Current Reuse Cascaded Linearity Improving Ultra-Wideband Low-Noise Amplifier

New Implementation of High Linear LNA Using Derivative Superposition Method