Abstract:In this paper, by constructing a 3-DOF (Degrees of freedom) laser interferometer on each displacement axis of motion, the main errors during the coordinate measuring machines (CMM) motion are dynamically monitored. The 3-DOF laser interferometer is composed of three-beam dual-frequency laser interferometers, and each dual-frequency laser interferometer obtains the reflection signal through a corner cube reflector. By determining the position parameters of the three corner cube reflectors and three sets of feedback signals, the 3-DOF laser interferometer can calculate the three parameters, i.e., the axial displacement and the lateral pitch and yaw angles. The device is installed on each motion axis of the CMM to monitor 9 major errors during the whole motion system. Laser signals are used to track position information by establishing the rigid body transformation relationship. Therefore, the 9 errors can be updated in real time through the monitoring system to replace the calibration results to calculate the probe position. The position error of the CMM probe caused by the dynamic error is simulated. Monte Carlo method is employed to obtain the error situation and monitor the residual error distribution throughout the measurement movement process. The errors can be corrected immediately without recalibrating the CMM error parameters especially when the dynamic error changes significantly. In addition, environmental errors are also introduced in the model to analyze the impact on the accuracy of position monitoring. The method proposed can reduce the position monitoring error within 0.1 mu m. Using this method, the error source of a dynamic error monitoring system can be designed in a simulated environment, which can be used as the basis for the design of the dynamic error monitoring system.

Analysis and Compensation of Synchronous Measurement Error for Multi-Channel Laser Interferometer

A Three-dimension High-Precision and Non-contact Dynamic Angular Displacement Measurement System based on Heterodyne Interference

Four Degree-Of-Freedom Geometric Error Measurement System with Common-Path Compensation for Laser Beam Drift

A High-Precision Five-Degree-Of-Freedom Measurement System Based on Laser Collimator and Interferometry Techniques

Simultaneous Measuring Method Of Linear Guide Geometric Errors In Four-Degrees Of Freedom

A Novel Method to Simultaneously Measure the Straightness

Development of a simple system for simultaneously measuring 6DOF geometric motion errors of a linear guide.

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Mathematic Model of Simultaneously Measuring Six-dimensional Parameters by Laser

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

Modified Homodyne Laser Interferometer Based on Phase Modulation for Simultaneously Measuring Displacement and Angle.

Modeling And Simulation Of Dynamic Errors In A Coordinate Measuring Machine With 3-Dof Laser Interferometer

Synchronous measurement of velocity and distance with high resolution based on comb reference common-path interferometric FMCW lidar

Effect of Dual-Channel Optical Feedback on Self-Mixing Interferometry System

Laser self-mixing interferometry for dynamic displacement sensing of multiple targets

An algorithm for the compensation of geometrical error in laser interferometer measurement

Equivalent Measurement and Real-Time Compensation of Error Caused by Intensity Change in Deep Sub-Nanometer Displacement Measuring Interferometry

Multi-Axis Laser Interferometer Not Affected by Installation Errors Based on Nonlinear Computation

A calibration approach for installation error of multi-axis laser interferometer

A Real-Time Nonlinear Error Measurement Method with Picometer Accuracy and Free from Target Motion State

Error Analysis and Compensation in Laser Interferometry