Abstract:REBCO coated conductors are now being used for building very high-field magnets with large electromagnetic stresses, both expected ones due to transport current × stresses and additional stresses resulting from the large screening currents inherent in wide tapes. Post mortem analyses of several recent test coils operated above 40 T show that significant conductor plastic deformation occurs, even for JBR stresses well below the ~1 GPa yield of the Hastelloy substrate of the conductor. To investigate these deformation mechanisms, conductors were unwound after coil test and carefully examined with respect to their length-wise Ic which revealed many areas of local damage. Regions of interest were examined by metallographic cross-section, Hall microscopy, magneto-optic imaging and scanning electronic microscopy. Important damage frequently occurred to the outer edges of pancakes in the coil ends, which were often plastically deformed over the whole turn circumference, especially when this outer edge was a slit edge. Internal conductor damage was also seen, especially delamination between the buffer and REBCO layers at slit edges. Careful sectioning of the tape at ~10 mm intervals showed that the plastic deformation of the turns was complex and variable around the turn circumference, with tape cross-sections that exhibited continuous shape change in the outer turns. The bending center line of tapes often shifted from the tape center line toward the edge closest to the coil center, indicating asymmetric effects of transport and screening current stresses across the conductor width. A surprising and vital result is that damage was prevalent when the slit edge was also the edge at which transport current flowed. This damage was absent when the transport current flowed at the not-slit edge, implying great sensitivity of the effect of screening current stresses to localized conductor damage.

Observation And Analysis Of Defects In Impregnated Ybco Racetrack Coil

Development of a 400 M YBCO Racetrack Coil for HTS Machine Applications

<i>In situ</i> detection of delamination and critical current degradation caused by the thermal stress in epoxy impregnated REBa<sub>2</sub>Cu<sub>3</sub>O<sub>7</sub>- coils

The stability of the high temperature superconducting DC coils with defects

The experimental research and analysis on the quench propagation of YBCO coated conductor and coil

Delamination Properties of YBCO Tapes Under Shear Stress Along the Width Direction

Continuous Critical Current Measurement of High-Temperature Superconductor Tapes with Magnetic Substrates Using Magnetic-Circuit Method.

Quench Protection of YBCO Coils: Co-Winding Detection Method and Limits to Hot-Spot Temperature

Degradation-Free Impregnated YBCO Pancake Coils by Decreasing Radial Stress in the Windings and Method for Evaluating Delamination Strength of YBCO-Coated Conductors

Critical Current Survival in the YBCO Superconducting Layer of a Delaminated Coated Conductor

Analysis of Technical Routes to Fabricate HTS Coated Conductors

A standardized measurement method and data analysis for the delamination strengths of YBCO coated conductors

Examination and Analysis of Critical Current Uniformity of Long HTS Tapes by the MCorder

HREM STUDY ON THE DEFECTS OF Y-Ba-Cu-O SUPERCONDUCTORS

Test and Analysis of Electromagnetic and Mechanical Properties of HTS Coil During Quench State

Delamination behaviors of an epoxy-impregnated REBCO pancake coil during a quench

Critical current degradation and delamination crack observation of epoxy-coated REBCO superconducting tapes after thermal cycles in liquid nitrogen

Local electromagnetic properties and hysteresis losses in Non-Uniformly wound 2G-HTS Racetrack Coils

Characterization of I-c Degradation in Bent YBCO Tapes

Analyses of the plastic deformation of coated conductors deconstructed from ultra-high field test coils

Preparation and Critical-Current Measurements of Laser-Ablated Ybco Superconducting Thin-Films