Abstract:The current-voltage characteristics of superconductors are commonly determined by means of a standard 4-probe DC measurement technique. In coated conductors, however, one often encounters problems due to weak or no stabilization and in such case, when the risk of burning the tape is high, the 4-probe approach can fail. In other cases such as in HTS cable structures, besides vulnerability and high risk of damage, it may also be difficult to achieve a high critical current level with a power supply that is normally used to characterize single strands. We therefore investigated an alternative method to determine the DC I-V curve, based on measuring the AC transport loss as a function of frequency in overcritical current range. In the AC regime, both the hysteretic loss component and the joule dissipation are present for applied transport currents exceeding the critical current Ic. In this work, AC loss measurements at different frequencies are related to different electric fields in DC and a curve similar to the DC I-V is obtained. From this curve, the power index N and Ic values are estimated. AC regime operation can be more beneficial for two reasons: firstly, because very high currents can be achieved easily by using a transformer; secondly, because the effective joule heat dissipation with overcritical AC currents is much lower than that with DC of the same amplitudes. In the experiment, we used a 4 mm wide YBCO reference tape with 20 {\mu}m of Cu-stabilization. For the comparison with AC transport loss, the sample was measured with the standard 4-probe technique and remained stable even in overload condition. To support our study, numerical simulations, reproducing both transient and stationary operation conditions, were performed. A similar relation between the AC current transport loss and the I-V curves was also observed in the simulations.

Continuous Critical Current Measurement of High-Temperature Superconductor Tapes with Magnetic Substrates Using Magnetic-Circuit Method.

A Method for Continuous Measurement of Critical Current of HTS Tapes Using Magnetic Circuits

Contactless Measurement of Critical Current of High Temperature Superconductor Tape by Magnetic Circuit.

Method and Apparatus for Continuous $i_{\rm C}$ Examination of HTS Tape Using Magnetic Circuit

Method and Apparatus for Continuous Examination of HTS Tape Using Magnetic Circuit

Examination and Analysis of Critical Current Uniformity of Long HTS Tapes by the MCorder

Method And Apparatus For Continuous I-C Examination Of Hts Tape Using Magnetic Circuit

MethodandApparatusforContinuous Examination of HTS Tape Using Magnetic Circuit Chen Gu, Timing Qu, Shengnan Zou, and Zhenghe Han

Design for In-Field Critical Current Measurement System With 102 Mm 15 T Background Magnet

Measurement of the Transition Temperature Distribution and Magnetic Field Profile of Large Superconducting Films

Comparative study of current carrying capacity between 1G and 2G HTS tape samples at different temperatures and magnetic fields

Magnetic Field Angle Dependence of Critical Current in REBCO Tapes Produced by Different Techniques

Experimental study on the an-isotropic critical current of REBCO tape

Characterization of I-c Degradation in Bent YBCO Tapes

Simple test for high Jc and low Rs superconducting thin films

Determination of I-V Curves of HTS Tapes From The Frequency Dependent AC Transport Loss

Transversal Thermal Conductivity of HTS Tapes: Analytical Method vs Measurements

Magnetic Field and Temperature Scaling of the Critical Current of REBCO Tapes

Quench Protection of YBCO Coils: Co-Winding Detection Method and Limits to Hot-Spot Temperature

Preparation and Critical-Current Measurements of Laser-Ablated Ybco Superconducting Thin-Films

Long-time stable HTSC DC-SQUID gradiometers with silicon dioxide passivation for measurements with superconducting flux transformers