Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Quench Protection of YBCO Coils: Co-Winding Detection Method and Limits to Hot-Spot Temperature

A quench detection method for parallel co-wound HTS coils based on current redistribution

A Quench detection method for closed-loop superconducting coils based on currents redistribution in co-windings

The experimental research and analysis on the quench propagation of YBCO coated conductor and coil

Two Quenched Models for High-Temperature Superconducting Insulated Coils

Test and Analysis of Electromagnetic and Mechanical Properties of HTS Coil During Quench State

Continuous Critical Current Measurement of High-Temperature Superconductor Tapes with Magnetic Substrates Using Magnetic-Circuit Method.

Observation And Analysis Of Defects In Impregnated Ybco Racetrack Coil

Quench Detection System for the KSTAR Superconducting Toroidal Field Coil

Experimental research on thermal stability of conduction-cooled YBCO magnet for induction heating

A new quench detection method for HTS magnets: stray-capacitance change monitoring

Quench Detection Based on Voltage Measurement for the Kstar Superconducting Coils

Thermal Diffusion and Quench Propagation in YBCO Pancake Coils Wound with ZnO-and Mylar Insulations

Characteristics of Pumping Current in a YBCO Coil by a Pulse-Type Magnetic Flux Pump

Development of a 400 M YBCO Racetrack Coil for HTS Machine Applications

A Real-time Monitoring System for Investigating Electromagnetic Behaviors of An HTS Coil

Performance of an HTS Generator Field Coil under System Fault Conditions

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Designs and Tests of Shaking Coils to Reduce Screening Currents Induced in HTS Insert Coils for NMR Magnet

High-Tc Superconductor Detection Coils for a Magnetic Resonance System

Toward an Encapsulated LTS Quench Detector for Fast Quench Detection in HTS Magnets