Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Test and Analysis of Electromagnetic and Mechanical Properties of HTS Coil During Quench State

Design and Test Performance of 2g Pancake Coils for Hts Dc Induction Heater Prototype

Development of a Conduction-Cooled HTS SMES

Two Quenched Models for High-Temperature Superconducting Insulated Coils

A Real-time Monitoring System for Investigating Electromagnetic Behaviors of An HTS Coil

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

A quench detection method for parallel co-wound HTS coils based on current redistribution

Performance of an HTS Generator Field Coil under System Fault Conditions

An electromagnetic-thermal-mechanical coupling model of dry-wound HTS coil based on T-A formulation with Neumann boundary condition

Quench Protection of YBCO Coils: Co-Winding Detection Method and Limits to Hot-Spot Temperature

Manufacture and Preliminary Prototype Test of a HTS Suspension Electromagnet for Maglevs

Design, Fabrication and Testing of a Heater-Trigged High-Tc Superconducting Power Supply

AC Analysis of a High Temperature Superconductor Coil with Short Circuits

Quench Test Of Hts Coils For Generator Application At Ge

Electromagnetic-thermal-mechanical behaviors of a no-insulation double-pancake coil induced by a quench in the self field and the high field

Development of Testing Device for Critical Current Measurements for HTS/LTS

Electromagnetic Design of HTS D-shaped Coils for a Toroidal-type Superconducting Magnet

The stability of the high temperature superconducting DC coils with defects

Thermomechanical Behavior of the HL-LHC 11 Tesla Nb3Sn Magnet Coil Constituents during Reaction Heat Treatment

Analysis of mechanical behavior in inhomogeneous high-temperature superconductors under pulsed field magnetization

Over-Current Simulation Test for High Temperature Superconducting Generator