Abstract:Nb3Sn conductors are important candidates for high-field magnets for particle accelerators, and they continue to be widely used for many laboratory and NMR magnets. However, the critical current density, Jc, of present Nb3Sn conductors declines swiftly above 12-15T. State-of-the-art Ta- and Ti-doped strands exhibit upper critical field, Hc2, values of 24-26.5T (4.2K) and do not reach the FCC target Jc, which serves as the present stretch target for Nb3Sn development. As recently demonstrated, to meet this goal requires enhanced vortex pinning but an independent and supplementary approach is to significantly enhance Hc2. In this study, we have arc-melted multiple Nb alloys with added Hf, Zr, Ta and Ti and drawn them successfully into monofilament wires to investigate the possibilities of Hc2 enhancement through alloying. Hc2(T) was measured for all samples in fields up to 16T and some up to 31T. We have found that all alloys show good agreement with the standard Werthamer, Helfand, and Hohenberg (WHH) fitting procedure without the need to adjust the paramagnetic limitation parameter (alpha) and spin-orbit scattering parameter (lambda_so). The evaluation of dHc2/dT near Tc, which is proportional to the electronic specific heat coefficient (gamma) and the normal state resistivity (rho_n), allows a better understanding of the induced disorder introduced by alloying in the A15 phase. So far, we have observed that Hf alloying of pure Nb can enhance Hc2(0) by 3-4T to 28T, while adding just 1 at. %Hf or Zr into a Nb4Ta base alloy can raise Hc2(0) to 31T. Very importantly we find that Hf and Zr raise the alloy recrystallization temperature above the usual A15 reaction temperature range of 650°C-750°C, thus ensuring denser A15 phase nucleation in the Nb alloy grain boundaries, possibly leading to a more homogeneous A15 phase Sn content and refined A15 grain size. The potential for...

Thermomechanical Behavior of the HL-LHC 11 Tesla Nb3Sn Magnet Coil Constituents during Reaction Heat Treatment

Influence of heat treatment excursion on critical current and residual resistivity ratio of ITER Nb3Sn strands

Experimental verification of the temperature and strain dependence of the critical properties in Nb/sub 3/Sn wires

A Combined Testing and Modelling Methodology for the Mechanics of High-Field Superconducting Magnets

Study on internal strain distribution of the high-field Nb3Sn superconducting accelerator magnets with homogenization theory

Modeling heat transfer from quench protection heaters to superconducting cables in Nb3Sn magnets

Test and Analysis of Electromagnetic and Mechanical Properties of HTS Coil During Quench State

Self-protected high-temperature superconducting demonstrator magnet for particle detectors

Simulation of Thermo-Mechanical Stresses After a Quench in the 15 T Test Facility Dipole Magnet

Assessment of Training Performance, Degradation and Robustness of Paraffin-Wax Impregnated Nb 3 Sn Demonstrator under High Magnetic Field

Mechanical Characterization of Low-Carbon Steels for High-Field Accelerator Magnets: Application to Nb$_{3}$Sn Low-$\beta$ Quadrupole MQXF

Numerical Study of the Electromagnetic-Thermal Characteristics During the Charging Process of Ultra-high Field HTS Insert Magnet

Mechanical performance evaluation of the CFETR central solenoid model coil design

Behavior during quenches of a 40 T magnet made of LTS and HTS parts

An Effective Thermal Conductivity and Thermomechanical Homogenization Scheme for a Multiscale Nb3Sn Filaments

Analysis of mechanical behavior in inhomogeneous high-temperature superconductors under pulsed field magnetization

Temperature Profile Measurements During Heat Treatment of BSCCO 2212 Coils

Structure, Magnetostrictive, and Magnetic Properties of Heat-Treated Mn42Fe58 Alloys

An Advanced Computational Approach for Evaluating Screening-Current-Induced Strain in REBCO HTS Coils Considering Electromagnetic-Mechanical Coupling

Models and experimental results from the wide aperture Nb-Ti magnets for the LHC upgrade

Influence of Nb Alloying on Nb Recrystallization and the Upper Critical Field of Nb3Sn