Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Modeling heat transfer from quench protection heaters to superconducting cables in Nb3Sn magnets

Commissioning, Performance, and Effect of the Quench Current-boosting Device on a Dedicated Superconducting Magnet

Hall Effect, Magnetoresistance, and Current Distribution in Quench Heaters

Modeling of Quench in the ITER Poloidal Field Coils

Holistic numerical simulation of a quenching process on a real-size multifilamentary superconducting coil

Protection Circuit and Quench Simulation of a 7 T Superconducting Magnet for Animal MRI

Simulation of Thermo-Mechanical Stresses After a Quench in the 15 T Test Facility Dipole Magnet

Thermomechanical Behavior of the HL-LHC 11 Tesla Nb3Sn Magnet Coil Constituents during Reaction Heat Treatment

Full 3D thermal-hydraulic and electric modelling of quench propagation in HTS conductors

A novel and coupled Electromagnetic and Electrothermal software for quench analysis of high field magnets

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

A new quench detection method for HTS magnets: stray-capacitance change monitoring

Two Quenched Models for High-Temperature Superconducting Insulated Coils

Models and experimental results from the wide aperture Nb-Ti magnets for the LHC upgrade

Thermal runaway criterion as a basis for the protection of high-temperature superconductor magnets

Behavior during quenches of a 40 T magnet made of LTS and HTS parts

Influence of Current Diffusion in Superconducting Magnet Fabricated by High Stabilizer Aluminum on Quench Propagation

Optimized Field/Circuit Coupling for the Simulation of Quenches in Superconducting Magnets

Minimum Quench Energy Of Nb$_3$Sn Wires With High Specific Heat Tape

Reduced Order Modelling for the Simulation of Quenches in Superconducting Magnets

Multiscale modelling on the multi-physical behaviors of high temperature superconducting magnets based on a combined global homogenization and local refinement scheme