Abstract:Comprehending the mechanical response of materials on an atomic level is pivotal in the optimisation of advanced materials with superior mechanical properties. This research article utilises the atomistic-scale based molecular dynamics simulations to report the uniaxial tensile behaviour of bicrystalline Ni-6Cu (Nickel – 94% and Copper – 6%) alloy incorporated with pre-existing faceted Σ3 [111] 60° {11 8 5} grain boundaries. The primary aim of this investigation is to comprehend the performance of bicrystalline Ni-6Cu alloy under varying thermodynamic conditions and to assess the influence of pre-existing faceted grain boundaries on its tensile behaviour. This work encompasses a range of strain rates (10 8 to 10 10 1/s) and temperatures (spanning from 100 to 900 K) for the uniaxial tensile deformation simulations. The outcomes unveil that the Young's modulus of Ni-6Cu alloy (with pre-existing faceted grain boundaries embedded in its domain) was inversely proportional to temperature and constant with respect to strain rate. For the same configuration, yield stress was inversely and directly proportional to temperature and strain rate, respectively. Interestingly, incipient plasticity in the tensile stress–strain response was observed at lower temperature and lower strain rate. From the microstructural point of view, at lower temperatures, the incoherent twin boundary served as a source for the nucleation of stacking faults; however, as the temperature increased, both the incoherent twin boundary and the tips of coherent twin boundary function as the source for stacking faults formation. Our simulations also verified the GB's anti-thermal (or non-Arrhenius) migration behaviour even under tensile load.

An insight into the strain rate dependence of tensile ductility of an ultrafine grained Cu matrix nanocomposite

Numerical investigation of fracture behavior of nanostructured Cu with bimodal grain size distribution

Tuning the Strength-Ductility Synergy of Nanograined Cu Through Nanotwin Volume Fraction

Modeling the Strain Rate-Dependent Constitutive Behavior in Nanotwinned Polycrystalline Metals

Computer Simulation of Strength and Ductility of Nanotwin-Strengthened Coarse-Grained Metals

Achieving High Strength and High Ductility in Nanostructured Metals: Experiment and Modelling

The Direct and Indirect Effects of Nanotwin Volume Fraction on the Strength and Ductility of Coarse-Grained Metals

Strain localization and ductile fracture mechanism of micro/mesoscale deformation in ultrafine-grained pure copper

Effect of compositional heterogeneity on the mechanical properties of a single-phase Cu-9Al alloy with different grain sizes

High tensile ductility in a nanostructured metal

In-situ surface study on the mechanism of high-strain-rate superplasticity in an Al–Cu–Li alloy

Strain hardening behavior and microstructure evolution of gradient-structured Cu-Al alloys with low stack fault energy

Enhanced strain hardening by bimodal grain structure in carbon nanotube reinforced Al–Mg composites

In-situ solid-state deformation-driven rapid reaction towards higher strength-ductility Al-CuO composites

Strain Rate Effect on Plastic Deformation of Nanocrystalline Copper Investigated by Molecular Dynamics

Achieving high strain rate superplasticity in an Al-Cu-Li alloy processed by thermo-mechanical processing

Activating dispersed strain bands in tensioned nanostructure layer for high ductility: The effects of microstructure inhomogeneity

Deformation Twinning Induced High Tensile Ductility of a Gradient Nanograined Cu-Based Alloy

Plastic strain-induced grain refinement at the nanometer scale in copper

Copper effects on the microstructures and deformation mechanisms of CoCrFeNi high entropy alloys

Synergistic effects of temperature and strain rate on tensile properties of simulated Ni-6Cu alloy with Σ3 non-Arrhenius grain boundary