Abstract:Al-Li alloy possesses remarkable advantages such as low density, high specific strength and specific elastic modulus, making it an exceptional aerospace structural material with considerable application potential. However, Al-Li alloy suffers from poor formability, which restricts its broader engineering applications. Alternatively, superplastic forming at high temperatures is widely applied for producing such components. Temperature is a key factor affecting the thermal deformation properties of Al-Li alloy. In this study, tensile tests of 2198 Al-Cu-Li alloy were conducted at different temperatures, and dedicated characterizations were performed to reveal the underlying mechanisms responsible for the hot deformation behavior. Results reveal that three distinct stages are observed in the superplastic deformation process of this alloy. Specifically, in the initial lowtemperature range (400 degrees C-450 degrees C), incomplete dynamic recrystallization (DRX), accompanied by grain rotation and elongation plays a dominant role in the hot deformation mechanism. In the middle temperature stage (450 degrees C-500 degrees C), both DRX and grain boundary sliding (GBS) occur. At the high-temperature stage (500 degrees C-550 degrees C), diffusion creep emerges as the prominent mechanism. Moreover, optimum superplasticity is achieved at 500 degrees C, which results from a synergistic combination of several factors, including grain refinement by DRX, an increased fraction of high-angle grain boundaries (HAGBs), reduced dislocation density and weak texture.

In-situ surface study on the mechanism of high-strain-rate superplasticity in an Al–Cu–Li alloy

Achieving high strain rate superplasticity in an Al-Cu-Li alloy processed by thermo-mechanical processing

Superplastic Deformation Mechanisms in Fine-Grained 2050 Al-Cu-Li Alloys

Superplastic Behavior of Al-Cu-Li Based Alloy

High Strain Rate Superplasticity in an Al–Mg–Sc–Zr Alloy Processed Via Simple Rolling

Quantitative Study Of Superplastic Deformation Mechanism Of 5a90 Al-Li Alloy

High Strain Rate Superplasticity of in situ Al 3 Zr/6063Al Composites

Realization of Exceptionally High Elongation at High Strain Rate in a Friction Stir Processed Al–Zn–Mg–Cu Alloy with the Presence of Liquid Phase

High Strain Rate Superplasticity in a Micro-grained Al{Mg{Sc Alloy with Predominant High Angle Grain Boundaries

Superplastic Deformation of an As-Rolled Al–Cu–Mg–Ag Alloy

Superplastic Behavior and Microstructure Evolution of A New Al-Mg-Sc-Zr Alloy Subjected to A Simple Thermomechanical Processing

Superplastic Deformation of a Heat-Resistant Al–Cu–Mg–Ag–Mn Alloy

Achieving High Superplasticity of a New Al–Mg–Sc–Zr Alloy Sheet Prepared by a Simple Thermal–mechanical Process

Superplastic behavior of 1420Al-Li alloy

High Strain Rate Quasi-Superplasticity Behavior in an Ultralight Mg-9.55Li-2.92Al-0.027Y-0.026Mn Alloy Fabricated by Multidirectional Forging and Asymmetrical Rolling

High Strain Rate Superplasticity in Al-Zn-Mg-Based Alloy: Microstructural Design, Deformation Behavior, and Modeling

Excellent superplasticity and deformation mechanism of Al–Mg–Sc–Zr alloy processed via simple free forging

SUPERPLASTIC BEHAVIOR OF COARSE-GRAINED Al-Mg ALLOY

Superplastic Behavior of an Al–Mg–Li Alloy

Extraordinary superplasticity at low homologous temperature and high strain rate enabled by a multiphase nanocrystalline network

Effect of Temperature on Superplastic Deformation Behavior of 2198 Al–Cu–Li Alloy