Abstract:As one of the typical nanostructures, nanotwins (NTs) have been utilized to evade the trade-off between strength and ductility, which is also applicable to improve the mechanical properties of superalloys. However, the optimization capability of mechanical properties by tailoring NTs has encountered bottleneck for the reasons such as inverse Hall-Petch effect and anisotropic effect. Based on the experimental observation of a special distribution pattern of NTs and nano-precipitates (NPs) in superalloys, that is, NPs are located at the twin boundaries (TBs), our work aims to study the distinctive synergistic deformation mechanism between NTs and NPs, which could become a new microstructure design strategy to optimize the mechanical properties of superalloys. Specifically, molecular dynamic (MD) method was employed to unveil the synergistic deformation mechanism of NTs and NPs in a model Ni-based superalloy. As expected, the introduction of NPs onto TBs can inhibit dislocation motion along or parallel to TBs, despite the softening deformation mode of NTs is activated. Moreover, the existence of NPs onto TBs can greatly improve the strengthening efficiency of NTs by impeding twin thickening/thinning. On the other hand, both phase boundaries and NPs interior have obstructive effect on dislocation motion, which could also be beneficial for material strengthening. More interestingly, anti-phase boundary (APB) structure will form along with the dislocations cutting through NPs. Subsequently, the APB structure can act as channels for dislocation slip and dislocation nucleation site induced by a kind of TB confinement effect, which may effectively accommodate plastic deformation. Our research outcomes could be utilized to facilitate the development of high-performance superalloys via rational collaborative design of NTs and NPs.

Computer Simulation of Strength and Ductility of Nanotwin-Strengthened Coarse-Grained Metals

The Direct and Indirect Effects of Nanotwin Volume Fraction on the Strength and Ductility of Coarse-Grained Metals

Tuning the Strength-Ductility Synergy of Nanograined Cu Through Nanotwin Volume Fraction

Tensile Failure Modes in Nanograined Metals with Nanotwinned Regions

Simulation of Ballistic Performance of Coarse-Grained Metals Strengthened by Nanotwinned Regions

Simulating Size and Volume Fraction-Dependent Strength and Ductility of Nanotwinned Composite Copper

Micromechanical simulation of fracture behavior of bimodal nanostructured metals

Modeling Grain Size Dependent Optimal Twin Spacing for Achieving Ultimate High Strength and Related High Ductility in Nanotwinned Metals

Micromechanical Simulation of Fracture Behavior of Nanostructured Metals with Bimodal Grain Size Distribution

Numerical investigation of fracture behavior of nanostructured Cu with bimodal grain size distribution

MODELLING THE YIELD STRENGTH AND DUCTILITY IN COMPOSITE NANOTWINNED COPPER

Micromechanical modeling for mechanical properties of gradient-nanotwinned metals with a composite microstructure

Achieving High Strength and High Ductility in Nanostructured Metals: Experiment and Modelling

Prediction of Mechanical Properties in Bimodal Nanotwinned Metals with a Composite Structure

Atomistic and Theoretical Insights on Nanoprecipitates-Controlled Strengthening Behavior for Optimum Mechanical Performance in Nanotwinned NiCoCr Alloys

Microstructure‐Property Relations in the Tensile Behavior of Bimodal Nanostructured Metals

The Limit Velocity and Limit Displacement of Nanotwin-Strengthened Metals under Ballistic Impact

Modelling the Plastic Deformation of Nanostructured Metals with Bimodal Grain Size Distribution

Numerical simulation of ballistic performance of bimodal nanostructured metals

3D microstructure-based simulations of strength and ductility of bimodal nanostructured metals

Atomistic insights into the synergistic effect of nanotwins and nano-precipitates on the mechanical behavior of superalloys