Abstract:To reduce the manufacturing difficulty and improve the robustness of traditional boron-lined detectors that may replace the He-3 counter, the honeycomb neutron converter-based gaseous neutron detector has been proposed. A drift electric field is applied to drive electrons ionized by a or Li-7 after the B-10(n, alpha)Li-7 reaction from their origination positions to the incident surface of the gas electron multiplier (GEM), which multiplies electrons and forms the neutron signal. As the working gas affects the energy deposition of a or Li-7, the transverse diffusion of electrons in the migration process, as well as the multiplication of electrons in the GEM detector, the working gas selection of the honeycomb converter-based detector would be very important. Fourteen different working gases are investigated in detail through simulation research. Four working gases, Ar: iC(4)H(10): CF4 = 90: 7: 3, Ar: CO2 = 95: 5, Ar: CH4 = 90: 10, and Ar: DME = 95: 5, are experimentally tested. Both the simulation and experimental results demonstrate that working gases of Ar: iC(4)H(10): CF4 = 90: 7: 3, Ar: CO2 = 95: 5, and Ar: DME = 95: 5 show good performances benefitting from both the large stopping powers of a or Li-7 and the small transverse diffusion coefficients of electrons. The simulation results indicate that the detection efficiency with one of the three gases is 1.33 to 1.48 times the Ar: CH4 = 90: 10, while the experimental results demonstrate that there is 1.34-1.49 times of the detection efficiency. The research in this paper helps improve the performance of the honeycomb converter-based neutron detector.

The Research Of High Detection Efficiency Boron Lined Detector With A Honeycomb Neutron Converter

Research on a Neutron Detector With a Boron-Lined Honeycomb Neutron Converter

The Study of Boron-Lined Honeycomb Neutron Detector with a Multi-Wire Proportional Chamber Readout

Neutron imaging and spatial resolution evaluation of the boron-lined honeycomb neutron converter based detector

Study of uniform drift electric field used for boron-lined honeycomb neutron detector

Study of boron-lined straw-tube detector array for neutron scattering measurement

Research of boron lined honey-neutron detector realized with atomic layer deposition

The Research on the Suppression of Spurious Neutrons for A Neutron Detector Array That May Be Used in the Neutron Scattering

The Research on the Effect of Boron Layer Roughness for the Detection Efficiency of Boronlined Gaseous Neutron Detector

Development and performance evaluation of a multi-layer boron-lined detector for the CPHS-SANS instrument

A large area, high counting rate micromegas-based neutron detector for BNCT

An Angular Sensitivity Study of the Boron-Lined Honeycomb Convertor Neutron Detector Used for the Small Angle Neutron Scattering

Method for stabilizing the detection efficiency of grazing angle incidence boron-lined neutron detectors

Study of Boron Coated Straw Detectors for Small Angle Neutron Scattering on Cphs

Suppression of Spurious Neutrons for the Neutron Detector Used in Small Angle Neutron Scattering

Study Of Delay-Line Readout For Boron Coated Straw Detector

Working Gas Selection of the Honeycomb Converter-Based Neutron Detector

The role of stopping layer and conversion structure on fast neutron imaging

Boron-10 lined RPCs for sub-millimeter resolution thermal neutron detectors: Conceptual design and performance considerations

A double-helix neutron detector using micron-size B-10 powder

Boron-10 layers, Neutron Reflectometry and Thermal Neutron Gaseous Detectors