Abstract:We present the results of the measurements of the detection efficiency for a 4.7 \r{A} neutron beam incident upon a detector incorporating a stack of up to five MultiWire Proportional Counters (MWPC) with Boron-coated cathodes. The cathodes were made of Aluminum and had a surface exhibiting millimeter-deep V-shaped grooves of 45{\deg}, upon which the thin Boron film was deposited by DC magnetron sputtering. The incident neutrons interacting with the converter layer deposited on the sidewalls of the grooves have a higher capture probability, owing to the larger effective absorption film thickness. This leads to a higher overall detection efficiency for the grooved cathode when compared to a cathode with a flat surface. Both the experimental results and the predictions of the GEANT4 model suggests that a 5-counter detector stack with coated grooved cathodes has the same efficiency as a 7-counter stack with flat cathodes. The reduction in the number of counters in the stack without altering the detection efficiency will prove highly beneficial for large-area position-sensitive detectors for neutron scattering applications, for which the cost-effective manufacturing of the detector and associated readout electronics is an important objective. The proposed detector concept could be a technological option for one of the new chopper spectrometers and other instruments planned to be built at the future European Spallation Source in Sweden. These results with macrostructured cathodes generally apply not just to MWPCs but to other gaseous detectors as well.

Boron-10 lined RPCs for sub-millimeter resolution thermal neutron detectors: Conceptual design and performance considerations

Multilayer $^{10}B$-RPC neutron imaging detector

Timing resistive plate chambers for thermal neutron detection with 3D position sensitivity

Concept of a fast neutron detector based on 10B-RPCs

In-beam test results of an RPC-based module for position-sensitive neutron detectors with timing readout

Boron-10 layers, Neutron Reflectometry and Thermal Neutron Gaseous Detectors

A 10B-based neutron detector with stacked Multiwire Proportional Counters and macrostructured cathodes

The Study of Boron-Lined Honeycomb Neutron Detector with a Multi-Wire Proportional Chamber Readout

Conceptual design and first results for a neutron detector with interaction localization capabilities

Fast neutron sensitivity of neutron detectors based on boron-10 converter layers

Monte Carlo simulation study of RPC-based 0.511 MeV photon detector with GEANT4

Experimental Research on A Boron-Coated Multi-Wire Proportional Chamber Neutron Detector

Investigation of gamma-ray sensitivity of neutron detectors based on thin converter films

Research on a Neutron Detector With a Boron-Lined Honeycomb Neutron Converter

Boron-10 conversion layer for ultra-cold neutron detection

TDC Based on FPGA of Boron-Coated MWPC for Thermal Neutron Detection

The Research Of High Detection Efficiency Boron Lined Detector With A Honeycomb Neutron Converter

Development of a novel neutron detection technique by using a boron layer coating a Charge Coupled Device

An underground cosmic-ray detector made of RPC

An improved underground cosmic-ray detector made of RPCs