Abstract:Boron lined gaseous detector is one of the alternative detector types that possibly replace the helium-3 counter. The most important problem in the realization of boron-lined gaseous detector is how to plate thin boron film on the surface of large area substrate. Though methods of PVD (physical vapor deposition) can plate B4C layer effectively with good thickness uniformity and adhesion, they suffer from the drawback that the area of substrate, typically 0.1 m2 in once coating process, is far smaller than required in SANS (small angle neutron scattering) spectrometry. ALD (Atomic layer deposition) technique, which is a kind of CVD (chemical vapor deposition) method, can plate boron on the surface of large aspect ratio (at most 2000:1) substrate, so it can accommodate large area substrates. Honeycomb detector, which is composed of many small honeycomb cells with 6 mm side length, has very large surface area and is placed inside the reaction chamber of ALD machine to deposit boron layer on the surface of it to realize high detection efficiency. BBr3 and H2O are used as precursors to form B2O3 layer and diethyl zinc and H2O are used as precursors to form ZnO film, the passivation layer. 0.04 mg/cm2 of B2O3 is deposited after 2250 cycles of growth. The boron lined honeycomb then is filled with 95% argon + 5% CO2 to be a proportional counter. Its neutron sensitivity is tested under the thermal neutron field provided by a photoneutron source. The preliminary result shows that the neutron sensitivity of the honeycomb detector would be 1.26 × 10-2 cm2 (for one cell) and 1.15 cm2 (for the whole detector).

Study of Boron Coated Straw Detectors for Small Angle Neutron Scattering on Cphs

Study Of Delay-Line Readout For Boron Coated Straw Detector

Experimental study of boron-coated straws with a neutron source

Study of boron-lined straw-tube detector array for neutron scattering measurement

Development and performance evaluation of a multi-layer boron-lined detector for the CPHS-SANS instrument

A multiplex readout method for position sensitive boron coated straw neutron detector

The Study of Boron-Lined Honeycomb Neutron Detector with a Multi-Wire Proportional Chamber Readout

Realization and Test of Position Sensitive Boron Coated Straw-Tube

Developments of a 2D position sensitive neutron detector

An Angular Sensitivity Study of the Boron-Lined Honeycomb Convertor Neutron Detector Used for the Small Angle Neutron Scattering

Boron-10 layers, Neutron Reflectometry and Thermal Neutron Gaseous Detectors

Research of boron lined honey-neutron detector realized with atomic layer deposition

The Research Of High Detection Efficiency Boron Lined Detector With A Honeycomb Neutron Converter

The Research on the Suppression of Spurious Neutrons for A Neutron Detector Array That May Be Used in the Neutron Scattering

Neutron imaging and spatial resolution evaluation of the boron-lined honeycomb neutron converter based detector

Realization and evaluation of doping and coating neutron sensitive MCP

Suppression of Spurious Neutrons for the Neutron Detector Used in Small Angle Neutron Scattering

Background Study for (n,) Cross Section Measurements with C6D6 Detectors at CSNS Back-n

An energy resolved neutron imaging detector based on boron doped nMCP coupled with a time stamping optical camera

Construction of a two-dimensional thermal neutron detector

Low Background Thermal Neutron Detector System