Abstract:The ultrahigh static displacement-acceleration sensitivity of a mechanical sensing chip is essential primarily for an ultra-sensitive accelerometer. In this paper, an optimal design to implement to a single-axis MOEMS accelerometer consisting of a grating interferometry cavity and a micromachined sensing chip is presented. The micromachined sensing chip is composed of a proof mass along with its mechanical cantilever suspension and substrate. The dimensional parameters of the sensing chip, including the length, width, thickness and position of the cantilevers are evaluated and optimized both analytically and by finite-element-method (FEM) simulation to yield an unprecedented acceleration-displacement sensitivity. Compared with one of the most sensitive single-axis MOEMS accelerometers reported in the literature, the optimal mechanical design can yield a profound sensitivity improvement with an equal footprint area, specifically, 200% improvement in displacement-acceleration sensitivity with moderate resonant frequency and dynamic range. The modified design was microfabricated, packaged with the grating interferometry cavity and tested. The experimental results demonstrate that the MOEMS accelerometer with modified design can achieve the acceleration-displacement sensitivity of about 150 mu m/g and acceleration sensitivity of greater than 1500V/g, which validates the effectiveness of the optimal design.

Design and Fabrication of the Tunneling Silicon Micro-Accelerometer

Fabrication, Characterization And Failure Analysis Of A Novel Mems Tunneling Accelerometer

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

A Bulk Micromachined Si-on-Glass Tunneling Accelerometer

Fabrication and Characterization of Tunneling Current of Anodic Bonded Dry-Etched MEMS Tunneling Accelerometer

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

A novel out-of-plane MEMS tunneling accelerometer

Design of Micro Tunneling Magnetometer and Research on its Fabrication Process

A Novel Out-Of-Plane Mems Tunneling Accelerometer With Excellent Low Frequency Resolution

High-precision micro-displacement sensor based on tunnel magneto-resistance effect

Design and Testing on High Sensitive Micro-accelerometer Based on HEMT

Fabrication and Characterization of A Microaccelerometer Based on Resonant-Tunneling Diodes

A Bulk Micromachined Si-on-glass Tunneling Accelerometer with Out-of-plane Sensing Capability

Long Range And Accurate Measurement Of Deep Trench Microstructures By A Specialized Scanning Tunneling Microscope

Design and Preparation of a High Resolution Accelerometer Based on Graphene

Fabrication Of Micro Tunneling Magnetometer And On-Wafer Test

A micromachined silicon resonant accelerometer

The Optimization and Fabrication of High Electron Mobility Transistors Integrated with Microstructure

Piezoresistive Slot-Cantilever Type Accelerometer Inspired from Spider'S Slit Sensilla

Design Optimization and Fabrication Process of MEMS Micro-Magnetometer Based on Tunneling Effect

Design, fabrication, and characterization of a high-sensitivity integrated quartz vibrating beam accelerometer