Abstract:Most accelerometers today are based on the capacitive principle. However, further miniaturization for micro integration of those sensors leads to a poorer signal-to-noise ratio due to a small total area of the capacitor plates. Thus, other transducer principles should be taken into account to develop smaller sensors. This paper presents the development and realization of a miniaturized accelerometer based on the tunneling effect, whereas its highly sensitive effect regarding the tunneling distance is used to detect small deflections in the range of sub-nm. The spring-mass-system is manufactured by a surface micro-machining foundry process. The area of the shown polysilicon (PolySi) sensor structures has a size smaller than 100 μm × 50 μm (L × W). The tunneling electrodes are placed and patterned by a focused ion beam (FIB) and gas injection system (GIS) with MeCpPtMe3 as a precursor. A dual-beam system enables maximum flexibility for post-processing of the spring-mass-system and patterning of sharp tips with radii in the range of a few nm and initial distances between the electrodes of about 30–300 nm. The use of metal–organic precursor material platinum carbon (PtC) limits the tunneling currents to about 150 pA due to the high inherent resistance. The measuring range is set to 20 g. The sensitivity of the sensor signal, which depends exponentially on the electrode distance due to the tunneling effect, ranges from 0.4 pA/g at 0 g in the sensor operational point up to 20.9 pA/g at 20 g. The acceleration-equivalent thermal noise amplitude is calculated to be 2.4–3.4 mg/Hz. Electrostatic actuators are used to lead the electrodes in distances where direct quantum tunneling occurs.

A Novel Out-Of-Plane Mems Tunneling Accelerometer With Excellent Low Frequency Resolution

A novel out-of-plane MEMS tunneling accelerometer

Fabrication, Characterization And Failure Analysis Of A Novel Mems Tunneling Accelerometer

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Monolithic Integrated Cavity Optomechanical Accelerometer Based on Push-Pull Photonic Crystal Zipper Cavity

A New Type of MEMS Accelerometer with Up-Tuning Structure

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

A Bulk Micromachined Si-on-glass Tunneling Accelerometer with Out-of-plane Sensing Capability

A Bulk Micromachined Si-on-Glass Tunneling Accelerometer

Fabrication and Characterization of Tunneling Current of Anodic Bonded Dry-Etched MEMS Tunneling Accelerometer

Development and Proof of Concept of a Miniaturized MEMS Quantum Tunneling Accelerometer Based on PtC Tips by Focused Ion Beam 3D Nano-Patterning

Design and Preparation of a High Resolution Accelerometer Based on Graphene

Design and Fabrication of the Tunneling Silicon Micro-Accelerometer

Study on lateral dual-element Electron Tunneling Accelerometer

Design, Fabrication, And Performance Characterization Of Ltcc-Based Capacitive Accelerometers

A Novel Capacitive Accelerometer with A Highly Symmetrical Double-Sided Beam-Mass Structure

A High-Performance MEMS Accelerometer with an Improved TGV Process of Low Cost

Design, fabrication, and characterization of a high-sensitivity integrated quartz vibrating beam accelerometer

A Novel Micro-Machined Out-of-Plane Resonant Accelerometer with Differential Structure of Different-Height Resonant Beams

A novel sandwich capacitive accelerometer with a symmetrical structure fabricated from a D-SOI wafer

A micromachined silicon resonant accelerometer