Abstract:Currently there still exist a large base of subcritical coal-fired boilers remaining in operation worldwide. Improving their thermal efficiency is critical for these units to reduce the cost of electricity and meet the increasingly stringent efficiency regulations. This paper presented an economic high temperature upgrading retrofit solution for these subcritical units in which the final superheat and reheat steam temperatures are elevated from 540 °C to 600 °C level while the steam pressures remain at subcritical such that the retrofit can be made with minimum modifications to the boiler to reduce retrofit cost and technical risk. A systematic analysis was first conducted to deduce the best boiler heating surface modification option to achieve such significant increase of boiler steam temperatures. The analysis shows that replacing part of the furnace water wall below the furnace exit with wall superheater is the most viable and economic boiler modification design. A three-dimensional computational fluid dynamics (CFD) simulation was then conducted for a typical 320 MW subcritical boiler design to verify the feasibility of this design and determine the area of furnace wall that needs to be modified to achieve the target steam temperatures. The results show that with only 3.6 m height of furnace wall replaced with wall superheater both the superheat and reheat steam temperatures can reach the target 600 °C level even without any modification made to the reheaters. With this heating surface modification design, the efficiency of the existing subcritical power plants can be improved considerably with minimum boiler retrofit work. More importantly, this technology is going to help the plant owners meet the increasingly stringent efficiency and emission regulations mandated by the government and place them in a better position to continue operating these units.

Analysis and Improvement of Design Defect in a Blowdown System of Sidewall Header

Safety Testing and Analysis of the Header of the Drawn Boiler with a Small Diameter and a Large Wall Thickness

Research & Development of Boiler Tube Wall Temperature Calculation System

An Analysis of the Water Wall Modification Scheme for a Chinese-made Once-through Boiler

Hydrodynamic characteristic calculation for a 600 MW unit onceGthrough tower boiler

Computational analysis on hydrodynamic characteristics and flow instability of an ultra supercritical 1000 MW double-reheat unit boiler

Analysis on the Steam Temperature Deviation of the Vertical Water Wall and the Adjustment Plan of the Throttle Ring for an Ultra-supercritical Boiler

Wear in low temperature reheater and low reheat steam temperature:reason analysis and retrofitting

Hydrodynamic Characteristics of Vertical Tubes With Low Mass Flux in Supercritical Pulverized Coal Boiler

Experimental Study of Intermediate Header Flow Distribution Characteristics of a Supercritical Once-through Boiler Operating at Variable Pressures

Steam Temperature Characteristics in Boiler Water Wall Tubes Based on Furnace CFD and Hydrodynamic Coupling Model

The Cold Hydrodynamic Characteristics Experiment and Study of Small Type Water-fire Tube Hot Water Boilers

SIMULATION AND ANALYSIS ABOUT WORN-OUT ON CONNECTING PIPE OF LOW-PRESSURE REHEATER FOR A BOILER OF 600 MW UNIT

Analytical and numerical investigations on the high temperature upgrading solution of subcritical boilers

Optimization of Large-Diameter Bell-Type Air Cap in CFB Boiler

Leakage of water-cooled wall tube in subcritical boiler

Optimization and reconstruction of superheater and reheater for a 1000 MW tower type boiler with double-reheat cycle

Adjustment on reheat steam temperature for a 660 MW double-reheat boiler

Retrofitting of 75 t/h tower type circulating fiuidized bed combustion boiler

INVESTIGATION OF AERODYNAMICS AND NOx EMISSION PROPERTY IN A 600MW UTILITY BOILER WITH DEFLECTED SECOND AIR SYSTEM

Design and Optimization of the Deaerator Steam Supply in Power Plant