Abstract:In this research, a linear low density polyethylene (LLDPE) was first melt blended with a series of high density polyethylenes (HDPE) with different molecular weights at a fixed ratio of LLDPE/HDPE=90/10 (w/w). The prepared HDPE/LLDPE blends were then injection-molded into specimen bars through a dynamic packing injection molding (DPIM) technique, in which an oscillating shear field was imposed on the melt by two pistons that move reversibly with the same frequency during the packing stage. The crystal morphology, orientation and tensile properties were characterized by scanning electron microscopy, two-dimensional wide-angle X-ray scattering and Instron, respectively. Compared with conventional injection molding, DPIM caused an obvious increase in tensile strength in the injection-molded bars. Interestingly, LLDPE blended with low molecular weight HDPE (LMW-PE) was found to possess much higher tensile strength than that blended with high molecular weight HDPE (HMW-PE). Shish–kebab morphology was observed for all blends obtained, regardless of the molecular weight of the HDPE. However, thicker but shorter lamellae were observed for the LLDPE/LMW-PE blend, corresponding to a higher melting temperature; while thinner but longer lamellae were seen for the LLDPE/HMW-PE blend, corresponding to a lower melting temperature. Furthermore, the phase miscibility between HDPE and LLDPE was found to increase with increasing HDPE molecular weight, which would affect the sensitivity of molecular chains for response to external shear. The changed miscibility, together with the changed entanglement density in different HDPE was responsible for the change in tensile strength and unique crystal morphology of LLDPE induced by adding HDPE.

Improvement of Mechanical Properties of HDPE Injection Samples by Vibration

Effect of Oscillatory Shear on the Mechanical Properties and Crystalline Morphology of Linear Low Density Polyethylene

Measurement and Analysis on Tensile Strength and Crystallinity of Vibrating Extruded High-Density Polyethylene(Hdpe) Sheet

Simultaneously achieving self-toughening and self-reinforcing of polyethylene on an industrial scale using volume-pulsation injection molding

Effect of Vibration Parameters on Properties of Polypropylene in Dynamic Plasticizing Process

HDPE/UHMWPE in Vibration Field and Property of Its Blown Film

Mechanical Properties of Dynamic Extruded PP by Coat-hanging Die

Experimental Study on Improving the Mechanical Properties of Material Extrusion Rapid Prototyping Polylactic Acid Parts by Applied Vibration

Study on the fusion properties of extruded foaming rigid PVC

Modification of polypropylene by melt vibration blending with ultra high molecular weight polyethylene

Study on the Effect of Axial Vibration of Screw in Plasticating Process (Extrusion Part)

THE EFFECT OF MECHANICAL VIBRATION ON CRYSTALLIZATION OF POLYPROPYLENE

Blending Recycled High-Density Polyethylene HDPE (rHDPE) with Virgin (vHDPE) as an Effective Approach to Improve the Mechanical Properties

Enhanced effect of thermal expansion process in rotational shear technology for high performance HDPE pipes

"Like binding a book": Interfacial improvement of pre-melted ultrahigh molecular weight polyethylene by pulse vibration molding

Unique crystal morphology and tensile properties of injection-molded bar of LLDPE by adding HDPE with different molecular weights

Effect of Viscosity Ratio on Morphology and Mechanical Properties of PP/HDPE Blend

Improvement of HDPE Extrusion Properties by Fluorocarbon Elastomers Additives

Evolution of the cavity structure of HDPE/UHMWPE blends during cold stretching

ULTRAVIOLET IRRADIATION MODIFICATION OF HDPE AND MECHANICAL PROPERTIES OF ITS BLEND WITH PVA

Study on Crystallization Kinetics of Partially Melting Polyethylene Aiming to Improve Mechanical Properties