Enhanced melt flow UHMWPE/HDPE blends melt spinning and performance study
Gonghao Wang,Jie Liu,Shengxue Qin,Hongbin Zhang,Haiping Zhou
DOI: https://doi.org/10.1002/pen.26811
2024-06-13
Polymer Engineering & Science
Abstract:Hot drawing properties of UHMWPE/HDPE blends. The extremely low melt flowability of ultra‐high molecular weight polyethylene (UHMWPE) is the primary obstacle to its melt processing. Particularly in melt spinning processes, the extremely high molecular weight of UHMWPE and the density of entangled molecular chains severely limit its production efficiency and monofilament performance. This study investigates the effect of flow modifiers on the melt spinning process of UHMWPE/HDPE blends, focusing on CaSt2, PEG, and CaSt2/silicone powder composite additives, and their impact on the standard tensile samples and monofilament tensile properties of UHMWPE/HDPE. The mechanism of additive influence on the tensile properties of UHMWPE/HDPE blends is analyzed through tensile strength testing, thermal analysis, and microscopic morphology observation. The results show that in standard tensile samples, CaSt2 or CaSt2/silicone powder composite additives can enhance the crystallinity of the blend, thereby improving its tensile strength. Conversely, adding PEG significantly reduces the crystallinity and tensile strength of the blend. The maximum tensile strength of CaSt2‐modified UHMWPE/HDPE monofilament is 1236.61 MPa. This enhancement is attributed to the lubricating effect of CaSt2, which simultaneously assists the molecular chains in the amorphous region, and the reorientation of the stress‐induced molten lamellar structure under tension, greatly promoting the formation of straight‐chain crystals in the monofilament. During hot drawing, PEG inhibits the formation of straight‐chain crystals in the monofilament, resulting in a 3.06% decrease in maximum crystallinity compared with standard tensile samples. When CaSt2 is combined with silicone powder, the additives tend to aggregate during hot drawing, and these larger aggregate particles hinder the orientation of molecular chains along the drawing direction, resulting in a 30.75% decrease in maximum tensile strength of the monofilament compared with the standard tensile samples. Highlights The tensile property of UHMWPE/HDPE blends modified with additives was discussed. Analytical techniques including DSC, SEM, and tensile strength tests were used. The maximum tensile strength of the monofilament can reach up to 1236.61 MPa. UHMWPE/HDPE/CaSt2 = 60/40/0.5 exhibits the best tensile property.
engineering, chemical,polymer science