Abstract:Microinjection molding is a novel frontier polymer processing strategy different from conventional ones. In this paper, three different cavity-sizes of micro-mold tools were firstly fabricated, and the influences of micro-mold cavity dimension on the phase morphology structure, crystallization and orientation, and mechanical performance of the microinjection molded polylactic acid (PLA)/polycaprolactone (PCL) blend microparts were carefully investigated accordingly. The results show that the reduction of the cavity size would result in much higher shear stress field and cooling temperature gradient, which is advantageous to the fibrillation and orientation of PCL-dispersed phase. Consequently, with decreasing the micro-mold cavity dimension from length 26 mm to 15 mm, the interfacial compatibility is improved, significantly increasing number of PCL fibers with smaller diameter are in situ formed in PLA matrix and their orientation degree also obviously increases, which is verified by SEM and 2D-WAXD measurements. The Differential Scanning Calorimetry (DSC) analysis shows that the decrease in cavity dimension causes the enhancement of PLA crystallization property due to shear-induced crystallization, which is reflected by the decreasing PLA cold crystallization temperature and increasing PLA crystallinity (almost doubling that of conventional macropart). As a result, the dynamic/static mechanical property measurements exhibit that with decreasing the cavity size, the storage modulus, and the loss modulus of PLA/PCL blend micropart increase, and the corresponding tensile strength, elongation at break, and Young’s modulus also present an obviously increasing tendency. The related investigations would provide some new spaces and insights for realization of high-performance of PLA/PCL blend micropart.

Experimental study on mechanical behaviors of injection molded PC/PMMA blends

The One/Multi-objective Optimization for Tensile Yield and Impact Strength Responses of Optical PC/PMMA Blends

Optimization of physical and mechanical properties of PC/ABS/PMMA blends by mixture design approach

PMMA-driven morphology modification and dramatic improvement in ductility for PVDF/PLA blends

The impact of injection molding process parameters on mechanical properties and microstructure of PC/ABS blends using Taguchi approach

Research on effect of ABS,MAH,DCP on property of PA6/ABS blend

Experimental and Modeling Study of the Compressive Behavior of PC/ABS at Low, Moderate and High Strain Rates

Experimental Investigation and Modeling of the Mechanical Properties of Construction PMMA at Different Temperatures

Core-Shell Particles Of Poly(Methyl Methacrylate)-Block-Poly(N-Butyl Acrylate) Synthesized Via Reversible Addition-Fragmentation Chain-Transfer Emulsion Polymerization And The Polymer'S Application In Toughening Polycarbonate

Investigation of Toughening Mechanisms in Elastomeric Polycarbonate Blends through Morphological and Mechanical Characterization at Small and Medium Strain Rates

Molecular dynamics simulations on miscibility, glass transition temperature and mechanical properties of PMMA/DBP binary system

Study on the injection-molding blends of PET and LCP

Study on the influence of in-mold sequential injection molding process parameters on mechanical properties of self-reinforced single composites

Effect of processing parameter changes on mechanical properties during injection molding: Amorphous versus semi‐crystalline materials

Effect of Compatibility on the Foaming Behavior of Injection Molded Polypropylene and Polycarbonate Blend Parts

Machinability of the Thermoplastic Polymers: PEEK, PI, and PMMA

Phase Separation of Impact‐modified PVC/PMMA Blends under Melt‐blending Conditions

Influence of Structure Gradients in Injection Moldings of Isotactic Polypropylene on Their Mechanical Properties

Research on high quality PC/ABS alloy

Effect of Micro-Mold Cavity Dimension on Structure Andproperty of Polylactic Acid/Polycaprolactone Blend Undermicroinjection Molding Conditions

Segregation Behavior of Miscible PC/PMMA Blends during Injection Molding