Machinability of the Thermoplastic Polymers: PEEK, PI, and PMMA

Ying Yan,Yu Mao,Bo Li,Ping Zhou

DOI: https://doi.org/10.3390/polym13010069

IF: 5

2020-12-26

Polymers

Abstract:The thermoplastic polymer such as poly(methyl methacrylate) (PMMA), polyetheretherketone (PEEK), and polyimide (PI) is a kind of polymer material with properties of good mechanical strength. It has been widely used in the fields of aerospace, optical engineering, and microfluidics, etc. Thermoplastic polymers are considered to be one of the most promising engineering plastics in the future. Therefore, it is necessary to further study its mechanical properties and machinability, especially in ultra-precision machining. Furthermore, mechanical property and machinability were studied in this work. Through the dynamic mechanical analysis experiment, the elastic modulus and temperature effect of PMMA, PEEK, and PI are analyzed. In addition, the high-speed micromilling experiment is conducted to show that the surface roughness, burrs, and cutting chip characteristics in the high-speed micromilling process. In general, the surface quality of the brittle removal is generally better than that of the viscoelasticity state. The results show that PMMA, PEEK, and PI have good mechanical properties and machinability. Base on the results, the material will be in a viscoelastic state as the temperature increases. The surface quality of the brittle removal is generally better than the viscoelastic state.

polymer science

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the mechanical properties and machinability issues of thermoplastic polymers (such as polymethyl methacrylate (PMMA), polyether - ether - ketone (PEEK) and polyimide (PI)) during micromilling. Specifically, the research aims to analyze the elastic modulus, temperature effects, as well as surface roughness, burrs and chip characteristics of these materials through dynamic mechanical analysis experiments and high - speed micromilling experiments, so as to optimize the process parameters of these polymer materials in micro - scale and ultra - precision machining. The paper focuses on how to obtain good surface quality and dimensional accuracy under different processing conditions while reducing burr formation. Through this research, the behavior of these materials at different temperatures can be better understood, especially the influence of the transition between the glassy state, viscoelastic state and rubbery state on the processing quality.