Abstract:An experimental study is conducted on localized bulging of inflated latex rubber tubes of a range of wall thicknesses and tube lengths, guided by newly emerged analytical results. In the case when the tube has one free closed end that may or may not be subjected to a dead weight, the initiation pressure for localized bulging is determined by a bifurcation condition, and the propagation pressure is determined by Maxwell's equal-area rule. It is shown that after bulge initiation the pressure will decrease monotonically towards, but will never reach, the propagation pressure, and it is when the pressure is sufficiently close to this propagation pressure that rapid propagation of the bulge in the axial direction takes place. It is found that the experimentally observed initiation pressure is around 15% below the theoretical prediction, which is consistent with the fact that bulging initiation is a sub-critical phenomenon and is therefore sensitive to imperfections. The experimentally observed propagation pressure is always very close to the theoretical prediction, which confirms the insensitivity of this pressure to imperfections and demonstrates the predictive power of the material model fitted from our own experiments on equibiaxial stretching. In the other case when the tube is first stretched and then fixed at both ends, bulge initiation takes place in the same manner as in the previous case, but the propagation pressure is no longer determined by Maxwell's equal-area rule. After bulge initiation the pressure will first decrease to a minimum and then rises slowly, and it is on the latter ascending path that the bulge starts to propagate rapidly in the axial direction. A semi-analytical method is proposed for the determination of the minimum pressure. Numerical simulations with the use of the software Abaqus are also conducted to verify the theoretical predictions. (C) 2018 Elsevier Ltd. All rights reserved.

Application of LBB Concept to Single-Curvature Polyhedron Hydro-bulging Technology for Manufacturing Spherical Vessels

Study on Application of the Single-Curvature Polyhedron Hydro-Bulging Technology in Metallic Reactor Containment

Study on Manufacture of Container Heads by Two-Step Hydro-Bulging of Single-Curvature Polyhedron

Experiment and finite element analysis on pressure distention of laser welding dimple jacket

FLUID DYNAMICS AND CONTACT STRESS ON HARD SEALING SURFACE ANALYSIS OF LNG CRYOGENIC BALL VALVE

Simplified theoretical solution and practical calculation method for welded hollow spherical joints of rectangular hollow section members

Design and Manufacturing Process of a New Type of Deep-Sea Spherical Pressure Hull Structure

Effect of Polar Plate Dimension of Single Curvature Polyhedron on Its Hydrobulging Process

Free bulging of thin-walled cylinders closed by two heavy plates

Buckling properties of bulged barrels under external pressure

Research on the deformation mechanism of egg-shaped shells in granular medium bulging

Test Research on Limit Load of Spherical Vessel with Elliptical Nozzle

Experimental study of dieless hydro-bulging near-soccer shape closed shell

Study on Numerical Simulation and Test of Hydro-bulging Axle Housings

Localized Perturbation Load Approach for Buckling Design of Thin-Walled Steel Cylindrical Shells under Partial Axial Compression

Synchronized Hydraulic Bulging Forming Technology of Three-Layer-Metal Tubes

The Hydroforming Process with Radial Self-energizing Seal for Manufacturing Bimetal-lined Pipe

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

An Experimental Study of Localized Bulging in Inflated Cylindrical Tubes Guided by Newly Emerged Analytical Results

Development of a Kind of Ultrahigh Pressure Integration Device for Hydro-bulging in the Common Press

Free bulging and nonlinear buckling of teardrop-shaped pressure hull