Abstract:Wrinkling in unsupported region is a worthy problem to be solved in sheet metal forming process. Sheet hydroforming is advantageous in the prevention of unsupported wrinkles. However, the simply increasing of liquid pressure is not enough to suppress the wrinkling even though with the occurrence of “reverse bulging effect” .11Normally, the unsupported areas of sheet metals during hydroforming are easy to be bulged along the reverse direction of deep drawing, this phenomenon can be regarded as a “reverse bulging effect”. In order to predict and control the wrinkling quantitatively in unsupported region for thin-walled shells with curved surface, a theoretical model on critical wrinkling stress was proposed by considering proper “reverse bulging effect” based on energy method. The influence of liquid pressure and other parameters on the critical wrinkling stress was analyzed. The critical loading path of the liquid pressure to control wrinkling was obtained by combining critical wrinkling stresses and circumferential stresses. An experimental setup for an extremely thin-walled shell with semi-ellipsoidal geometry was designed and manufactured to verify the theoretical model. It is found that at a certain punch stroke, the magnitude of the critical wrinkling stress increases and that of circumferential compressive stress decreases with the improvement of the liquid pressure. The critical loading path can be utilized to get well formed shells with a ratio of thickness to diameter equals 0.27% in the experiments. The proposed method can be applied to predict and control wrinkling in unsupported region for hydroforming of thin-walled shell with high accuracy and considerably reduced simulation time.

Effect of Polar Plate Dimension of Single Curvature Polyhedron on Its Hydrobulging Process

BENDING OF THIN REGULAR POLYGON PLATES

Unified Plastic Limit Solution for Thick-Walled Cylinder with Size Effect

Unified Solution of a Borehole Problem with Size Effect

Application of LBB Concept to Single-Curvature Polyhedron Hydro-bulging Technology for Manufacturing Spherical Vessels

Free bulging of thin-walled cylinders closed by two heavy plates

Numerical Simulation on Buckling of Combined Multilayered Unequal-Thickness Cylindrical Shell

Research of Directional Stress Distribution on the Fully Plastic Bulged Pressure Hull

Numerical Simulation Analysis on Buckling Load of Large Combined Cylindrical Shells

Prediction of Bearing Capacities and Fracture Processes in Open-Hole Plates Using a Hybrid Model of Peridynamics and FEM

The Numerical Simulation of Decreasing Flow Stress Scale Effect

Analysis of wrinkling during sheet hydroforming of curved surface shell considering reverse bulging effect

Numerical Investigations on the Deformation Styles and Stress Distributions of Hyperelastic/viscoelastic Spheres During Water Entry

Experimental and numerical analysis of hydrodynamic impact on stiffened side of three-dimensional elastic stiffened plates

Buckling of composite cylindrical shells with ovality and thickness variation subjected to hydrostatic pressure

Enhancement on plastic deformation of curved surface shell by sheet hydroforming with optimized pre-bulging process

Buckling Pressure of Imperfect Spherical Shell Damaged by Concentrated Impact Load

Destabilization of Cylindrical Shells Coupling Effect of Local Impact Load and Circumferential Pressure

Study on Numerical Simulation and Test of Hydro-bulging Axle Housings

Experimental investigation and computer simulation on dynamic buckling behavior of liquid-filled cylindrical shells under axial impact

Water impact of deformable spheres with vertical and oblique entries