Abstract:AP1000 nuclear power main pipe, a type of complicated thick-walled tube structure with both high and thick-walled nozzles, is one of the key parts in nuclear island. It is required to be manufactured by integral plastic forming technique. Up to now, no economical and efficient plastic forming process for AP1000 main pipe has been reported. To aim for forming the tube structure with a nozzle such as AP1000 main pipe, a radial upset-extruding (RUE) process was developed, in which the initial billet is an extruded tube with a hole. RUE process is an extrusion method which realizes radial outflow of the metal around the hole of tube billet through an axial upsetting force and restriction of dies. Thick-walled tube structure with a nozzle derived from AP1000 main pipe was simplified to be a thick-walled three-way pipe, on which RUE process was analyzed based. Combined with reduced scale model experiments, thermomechanical coupled finite element analysis integrated with recrystallization models of 316LN was performed to investigate RUE process. Metal flow, deformation distribution, recrystallization distribution, and extrusion load and clamping load in RUE process was analyzed. The experimental workpiece of pure lead based on reduced scale model validate metal flow behavior predicted by using numerical simulation. The results indicate that the essence of RUE process is to deflect the flow of the material around the orifice of the tube billet. The loads of dies are significantly sensitive to the initial forming temperature and the friction coefficient, while the impact of the extrusion velocity is negligible. RUE process could be used to form thick-walled tube structure with a nozzle, and it has a potential for solving the manufacture of AP1000 main pipe.

Study on Application of the Single-Curvature Polyhedron Hydro-Bulging Technology in Metallic Reactor Containment

Stresses Controllable Analysis and Optimal Design of Unique High Pressure Vessel Applied in Hydrogen Charge Station

Application of LBB Concept to Single-Curvature Polyhedron Hydro-bulging Technology for Manufacturing Spherical Vessels

Experimental Investigation on the Deformation and Damage of Steel Ribbon Wound Vessel for Hydrogen Storage under External Impact and Blast Loading

Study on Manufacture of Container Heads by Two-Step Hydro-Bulging of Single-Curvature Polyhedron

Experimental Investigation on Buckling of Ellipsoidal Head of Steel Nuclear Containment

Finite Element Reliability Analysis of Steel Containment Vessels with Corrosion Damage

Effect of Shape Imperfection on the Buckling of Large-Scale Thin-Walled Ellipsoidal Head in Steel Nuclear Containment

Hot Radial Upset-Extruding Process for Tube Structure with a Nozzle of 316LN Stainless Steel

Investigation on Structural Behaviors of Reactor Pressure Vessel with the Effects of Critical Heat Flux and Internal Pressure

Feasibility Study on Pre-stressed Concrete Pressure Vessel in Modular High Temperature Gas-Cooled Reactor

Installation Method for the Steel Container and Vessel of the Nuclear Heating Reactor

Comparative Study on Reactor Pressure Vessel Failure Behaviors with Various Geometric Discontinuities under Severe Accident

Effect of Grooves on Nucleate Boiling Heat Transfer from Downward Facing Hemispherical Surface

Deformation Characteristics and Sealing Performance of Metallic O-rings for a Reactor Pressure Vessel

Design and Manufacturing Process of a New Type of Deep-Sea Spherical Pressure Hull Structure

Numerical Investigation on the Thermal-Hydraulic Characteristics near a Corroded Lower Head of the Reactor Vessel During IVR-ERVC

Chinese Innovative Patent Technologies for the Reactor Pressure Vessel

Demonstration of Structural Integrity of Boiling Water Reactor Pressure Vessels under Ultimate Response Guideline Operation

Containment for the Low-Temperature District Nuclear-Heating Reactor

DEVELOPMENT OF LIGHTWEIGHT DESIGN AND MANUFACTURE OF HEAVYDUTY PRESSURE VESSELS IN CHINA