Abstract:Abstract The two-dimensional (2D) system analysis codes are usually used to design and analyze the modular pebble-bed High Temperature Gas-cooled Reactors (HTR). However, in some cases, three-dimensional (3D) characteristics, for example the 3D power distribution and temperature distribution due to a part of control rods movement, also need to be concerned. In this paper, based on the 200 MWe Pebble-bed Modular High Temperature gas-cooled Reactor (HTR-PM) design, a 3D system analysis code was used to analyze some three-dimensional characteristics in steady state, as well as the transient process caused by the asymmetric movement of control rods in the side reflectors. Under normal operations of HTR-PM, the control rods are inserted at certain heights and the primary coolant enters the Reactor Pressure Vessel (RPV) from the outer pipe of the coaxial hot gas duct. As a result, the fuel temperature has a relative circumferential deviation of about 1.64% on the outside of the pebble bed, while a very small deviation at the center of the bed. The temperature distribution of RPV is significantly affected by the position of the helium inlet as well. The analysis results showed that, during the transient process caused by the withdrawal of two control rods, the relative circumferential deviation of the fuel particle temperature on the outside of the pebble bed would increase to around 8.47%. However, because of heat conduction in relatively long distance, the movement of the control rods has very little effect on the circumferential temperature deviation of the fuel particles at the center of the bed. These 3D characteristics of HTR under different conditions demonstrate the good applicability of 2D and 3D system codes and will provide support for more accurate safety analyses in the future.

Feasibility Study on Pre-stressed Concrete Pressure Vessel in Modular High Temperature Gas-Cooled Reactor

Supercritical Steam Generator Design of Modular High-Temperature Gas-Cooled Reactor

Study on the reheater design used in the supercritical steam turbine power conversion cycle of MHTR

Research on PTS Transient Temperature Field of Key Position of RPV for Chashma Nuclear Power Plant

Design aspects of the Chinese modular high-temperature gas-cooled reactor HTR-PM

Economic potential of modular reactor nuclear power plants based on the Chinese HTR-PM project

Preliminary Study on Three-Dimensional Characteristics of Modular High Temperature Gas-Cooled Reactor

Coupling of Modular High-Temperature Gas-Cooled Reactor with Supercritical Rankine Cycle

THE STRATEGIC STUDY OF PEBBLE MODEL HIGH TEMPERATURE GAS-COOLED REACTOR PLANT WITH POWER GENERATION FEATURE AND INDUSTRIAL APPLICATION PROSPECT

ICONE19-43182 Economic Analysis of Multiple-module High Temperature Gas-cooled Reactor (MHTR) Nuclear Power Plants

Future Development of Modular HTGR in China after HTR-PM

Steady-state Thermal Fluids Analysis for the HTR-PM Equilibrium Core

Numerical investigation of the heat-release performance of a metal hydride reactor-integrated phase change material

One implementation of vented low pressure containment for HTR

Analysis of heat-loss mechanisms with various gases associated with the surface emissivity of a metal containment vessel in a water-cooled small modular reactor

Three-dimensional Numerical Investigation of Heat Transfer Process in the Reactor Cavity of HTR-10

ICONE15-10372 ANALYSIS OF THE CONTROL OF THE HIGH TEMPERATURE GAS-COOLED REACTOR NUCLEAR POWER PLANTS

Analysis Of Bypass Effect On A 250 Mw High Temperature Gas-Cooled Reactor

Study on Pressure Relief Transient for High Temperature Gas Cooled Reactor

An Evaluation of Designed Passive Core Makeup Tank (CMT) for China Pressurized Reactor (CPR1000)

Large Thermal Gradients on Structural Integrity of a Reactor Pressure Vessel Subjected to Pressurized Thermal Shocks