Abstract:Supercritical steam generator can further improve the power generation efficiency of high temperature gas-cooled reactor (HTGR). A supercritical steam generator design is proposed based on the experience of the subcritical once through steam generator of high temperature gas-cooled reactor-pebble bed module (HTR-PM) and the future development plan of HTGR. An one-dimensional steadystate thermalhydraulic code for the helical tube supercritical steam generator of HTGR was developed based on the thermal hydraulic code of HTRPM subcritical once through steam generator. The empirical correlations of convective heat transfer coefficients of supercritical fluids are different from that of subcritical fluids. Different empirical correlations of convective heat transfer coefficient for supercritical fluid were compared. Their influence on the thermal-hydraulic calculation results is found to be quite small due to the large thermal resistance of the primary side helium convection. The 100% load working condition and partial load working conditions were calculated using the developed code and the distributions of the parameters including temperature, velocity, convective heat transfer coefficient, etc., were obtained and analyzed. The secondary-side heat transfer coefficient reaches the highest value near the pseudo-critical point. The primary-side heat transfer coefficient increases with temperature because helium thermal conductivity increases with temperature. In the low temperature section with T22 as the tube material, the primary-side thermal resistance occupies more than 65%. In the high temperature section with 800H as the tube material, the thermal resistance of the primaryside and the tube wall are close. The thermal resistance of the secondaryside is always small. The secondaryside velocity varies intensely because of the severe change of density, while the primary-side velocity varies moderately. The hydraulic characteristic curves (pressure drop vs. flow rate) of different working conditions were calculated, and they all contain negative slopes which is not good for flow distribution and instability. The inlet throttling resistance coefficient of heat transfer tubes were added to avoid negative slopes of the curves. The critical throttling resistance coefficients of 100%-30% load working conditions are between 850-1600, and the value increases with decreasing power ratio.

Study on the reheater design used in the supercritical steam turbine power conversion cycle of MHTR

Supercritical Steam Generator Design of Modular High-Temperature Gas-Cooled Reactor

Coupling of Modular High-Temperature Gas-Cooled Reactor with Supercritical Rankine Cycle

Patterns Coupled with Once-Reheat Supercritical Steam Cycle for Modular High-Temperature Gas-Cooled Reactor

ICONE23-1474 DESIGN AND THERMAL-HYDRAULIC ANALYSIS OF SUPERCRITICAL STEAM GENERATOR IN HIGH-TEMPERATURE GAS-COOLED REACTOR

Design and application of the HTR-100 industrial nuclear power plant

Supercritical Steam Generator Design and Thermal Analysis Based on HTR-PM

Model-Based Load Following Control for Helical-Coiled Supercritical Steam Generator of MHTGR

A Study on Different Thermodynamic Cycle Schemes Coupled with a High Temperature Gas-Cooled Reactor

Modeling of the Supercritical Steam Generator of MHTGR in Engineering Simulator

Design aspects of the Chinese modular high-temperature gas-cooled reactor HTR-PM

Modeling and Control Scheme Design of a Multi-Modular High Temperature Gas Cooled Reactor Cogeneration Unit

Coordinated Control System Design and Verification of HTR-PM Plant

Experimental and Operational Verification of the HTR-10 Once-Through Steam Generator (SG): Heat-transfer and Hydrodynamic Features of the Once-Through Steam Generator

Experiment and Verification Test of the Once-Through Steam Generator of the 10 Mw High-Temperature Gas-Cooled Reactor Flow Stability of the Once-Through Steam Generator

Thermal-hydraulic Code Development and Analysis of HTGR Helical Tube Supercritical Steam Generator

Experimental Study on the Residual Heat Removal System in HTR-10

Research Method and Two-Phase Flow Stability of the Steam Generator of HTR-10

Dynamic Modeling and Control Characteristics of the Two-Modular HTR-PM Nuclear Plant

Combined Cycle-Coupled High-Temperature and Very High-Temperature Gas-Cooled Reactors: Part I-Cycle Optimization

Modeling of the Helium-Heated Steam Reformer for Htr-10