Abstract:Supercritical steam generator can further improve the power generation efficiency of high temperature gas-cooled reactor (HTGR). A supercritical steam generator design is proposed based on the experience of the subcritical once through steam generator of high temperature gas-cooled reactor-pebble bed module (HTR-PM) and the future development plan of HTGR. An one-dimensional steadystate thermalhydraulic code for the helical tube supercritical steam generator of HTGR was developed based on the thermal hydraulic code of HTRPM subcritical once through steam generator. The empirical correlations of convective heat transfer coefficients of supercritical fluids are different from that of subcritical fluids. Different empirical correlations of convective heat transfer coefficient for supercritical fluid were compared. Their influence on the thermal-hydraulic calculation results is found to be quite small due to the large thermal resistance of the primary side helium convection. The 100% load working condition and partial load working conditions were calculated using the developed code and the distributions of the parameters including temperature, velocity, convective heat transfer coefficient, etc., were obtained and analyzed. The secondary-side heat transfer coefficient reaches the highest value near the pseudo-critical point. The primary-side heat transfer coefficient increases with temperature because helium thermal conductivity increases with temperature. In the low temperature section with T22 as the tube material, the primary-side thermal resistance occupies more than 65%. In the high temperature section with 800H as the tube material, the thermal resistance of the primaryside and the tube wall are close. The thermal resistance of the secondaryside is always small. The secondaryside velocity varies intensely because of the severe change of density, while the primary-side velocity varies moderately. The hydraulic characteristic curves (pressure drop vs. flow rate) of different working conditions were calculated, and they all contain negative slopes which is not good for flow distribution and instability. The inlet throttling resistance coefficient of heat transfer tubes were added to avoid negative slopes of the curves. The critical throttling resistance coefficients of 100%-30% load working conditions are between 850-1600, and the value increases with decreasing power ratio.

ICONE23-1474 DESIGN AND THERMAL-HYDRAULIC ANALYSIS OF SUPERCRITICAL STEAM GENERATOR IN HIGH-TEMPERATURE GAS-COOLED REACTOR

Supercritical Steam Generator Design and Thermal Analysis Based on HTR-PM

Thermal-hydraulic Code Development and Analysis of HTGR Helical Tube Supercritical Steam Generator

ICONE23-2161 THERMAL-HYDRAULIC AND FLOW INSTABILITY ANALYSIS OF AN HTGR SUPERCRITICAL HELICAL TUBE STEAM GENERATOR

Study on Heat Transfer and Flow Instability of Supercritical Water in Vertical Tube

Supercritical Steam Generator Design of Modular High-Temperature Gas-Cooled Reactor

Heat transfer of supercritical pressure water in helical tubes

Research Method and Two-Phase Flow Stability of the Steam Generator of HTR-10

Experiment and Verification Test of the Once-Through Steam Generator of the 10 Mw High-Temperature Gas-Cooled Reactor Flow Stability of the Once-Through Steam Generator

Steady-state Thermal Fluids Analysis for the HTR-PM Equilibrium Core

Experimental and Operational Verification of the HTR-10 Once-Through Steam Generator (SG): Heat-transfer and Hydrodynamic Features of the Once-Through Steam Generator

Thermal–hydraulic feasibility analysis on uprating the HTR–PM

Simulation of A Once-Through, Helical-Coiled Steam Generator of High Temperature Gas-Cooled Reactor

Experimental Study of Steam Generator Stability of 10MW High Temperature Reactor

Mathematical Model and Dynamic Characteristics of Spiral-Style Super-Critical Steam Generator Used Htgr

Engineering Design , Analysis and Testing of Helium Circulator used in HTR-PM

Model-Based Load Following Control for Helical-Coiled Supercritical Steam Generator of MHTGR

Thermal–hydraulic Characteristics and Flow Instability Analysis of an HTGR Helical Tube Steam Generator

Study on the reheater design used in the supercritical steam turbine power conversion cycle of MHTR

Thermal Analysis of HTGR Helical Tube Once Through Steam Generators Using 1D and 2D Methods

Two Phase Flow Stability in the HTR-10 Steam Generator