Two-phase Flow Instability Characteristics of HTGR Once Through Steam Generators
Yang Su,Xiaowei Li,Xinxin Wu
DOI: https://doi.org/10.1016/j.nucengdes.2023.112697
IF: 1.7
2023-01-01
Nuclear Engineering and Design
Abstract:High Temperature Gas-cooled Reactors (HTGR) have the advantage of inherent safety compared with most Gen III reactors. They also have very high temperature, which make the plant have high electricity generation effi-ciency and have has the potential for hydrogen production. Once Through Steam Generator (OTSG) is respon-sible for transferring high temperature heat from primary loop helium to secondary loop composed of water and steam. The evaporation tubes of HTGR OTSG are very long due to the low heat transfer coefficient of helium convection over tube bundles. A Two-phase flow instability may occur in HTGR OTSG, which can cause pulsation of the mass flow rate, system pressure and temperature. This will not only interfere with the control system, but also cause thermal fatigue damage in the structures. Thus, it is important to predict and avoid two-phase flow instability in HTGR OTSG. Three types of flow instabilities are investigated for HTGR OTSG using both a linear analytical model and a nonlinear numerical model. They are flow excursion (or Ledinegg instability), density wave oscillation and pressure drop oscillation. For the nonlinear numerical model, RELAP5 software is adopted. Flow excursion and pressure drop oscillation are discussed based on the predicted hydraulic characteristic curve of HTGR OTSG (pressure drop vs. mass flow rate curve). Density wave oscillation is investigated using the transient variation of the outlet mass flow rate. For the linear analytical model, a set of ordinary differential equations are established using integration and small perturbation methods. The variables of differential equations are the length of the subcooling water region, the length of both the subcooling water and saturated two-phase regions, the average density of the saturated two-phase region and the inlet mass flux. The stability of OTSG is investigated using the eigenvalues of the coefficient matrix of the ordinary differential equations. Based on the results calculated using the linear analytical model and nonlinear numerical model, there is no flow excursion, pressure drop oscillation or density wave oscillation at the designed partial and full power levels (30%, 50%, 75% and 100%). Thus, HTGR OTSG can operate stably and have a sufficient safety margin at the designed power levels. Density wave oscillation will happen when decreasing system pressure. However, increasing inlet resistance coefficient can avoid density wave oscillation effectively. The tube lengths' influences on the stability boundary of OTSG are also investigated and it shows no strong dependency.